Quote:
Originally Posted by Citroënbender
Just finished applying cyanoacrylate to my Alfa’s HVAC panel rear.
The dials get their “notchy” feel from little sprung plungers which ride on ribs of the dial’s back edge. The plunger springs are too strong, the panel too weak and it all falls apart at the back. So I clean everything and shorten the springs to reduce tension, then reassemble in stages with super glue.
It’s such a rubbish design it should have been on a Territory ICC - then again, it uses ‘00s electronics, not eighties… Once this is reassembled, I can find out if the phantom unlocking was spilled coffee “glue” inside the panel or a faulty door actuator. |
I have no clue what you said, I'm pretty illiterate when it gets too technical.
