Welcome to the Australian Ford Forums forum.

You are currently viewing our boards as a guest which gives you limited access to view most discussions and inserts advertising. By joining our free community you will have access to post topics, communicate privately with other members, respond to polls, upload content and access many other special features without post based advertising banners. Registration is simple and absolutely free so please, join our community today!

If you have any problems with the registration process or your account login, please contact us.

Please Note: All new registrations go through a manual approval queue to keep spammers out. This is checked twice each day so there will be a delay before your registration is activated.

Go Back   Australian Ford Forums > Club and Speciality Forums > Forum Community Car Clubs > AU Falcon.com.au

Reply
 
Thread Tools Display Modes
Old 04-04-2009, 03:29 PM   #1
Chamelion
FF.Com.Au Hardcore
 
Join Date: Sep 2007
Location: Scarness, Hervey Bay.
Posts: 830
Default Shuddering issue and overheating

Hello all,

I've had a few problems with my 2002 AU3 I6 wagon lately..

3 times in the last couple of months I've been driving along and the car has started to shudder like it is being starved of fuel. I've looked down to notice the temp gauage at 3/4 the way to the red zone. I've stopped the car each time, checked under the bonnet and noticed nothing amiss.. well, I think one radiator fan it not working come to think of it.
As soon as I have turned on the cars cabin heater the temp guage drops at a very visible rate taking only seconds to return to normal. After that I have been able to turn the heater back off and then drive like normal. It's weeks between each time.

I've also had issues with the idle being eratic (worse on LPG) and then I'm going slow she often shudders and shakes (idle drops and again, worse on lpg) and it's even more pronounced if I'm turning and/or running the airconditioning.

Any thoughts or suggestions greatfully appreciated.

Matt.

PS: LPG was serviced less than a month ago, oil was changed at the same time, plugs could be getting old, leads are 15 months or so old, O2 sensor is of an unknown age, throttle body and ICS were last cleaned around a year ago and the air filter is a month old.

Chamelion is offline   Reply With Quote Multi-Quote with this Post
Old 04-04-2009, 04:15 PM   #2
Whoosha
AU DIE HARD
Donating Member1
 
Whoosha's Avatar
 
Join Date: Nov 2005
Location: Between 2nd and 5th gear
Posts: 5,073
Valued Contributor: For members whose non technical contributions are worthy of recognition. - Issue reason: For all the things you do behind the scenes. Tech Writer: Recognition for the technical writers of AFF - Issue reason: Writing tech articles 
Default

Sounds like a over heating issue. dont the I6 have the over heating protection ? if so I would give the thermostat the flick and try another one
__________________

........Age and treachery will ALWAYS overcome youth and skill.......


CORTINA 250 2V POWER soon to be AUXR8 Windsor pwrd


.............WINDSOR WARLORD WHO CARRIES THE CLEVO MAFIA AND BROKEN BOSSES...
..................................................

Quote:
Originally Posted by Riksta
Quote of the weekend: "The quarter mile wasn't as long as I expected it to be".
Whoosha is offline   Reply With Quote Multi-Quote with this Post
Old 04-04-2009, 09:14 PM   #3
mik
FF.Com.Au Hardcore
 
mik's Avatar
 
Join Date: Feb 2005
Location: Melb north
Posts: 12,025
Default

if the coolant level was down.... or too hot(turning to steam)the gas mixer might be freezing up, but probably more likely what Whoosha has said...... over heat protection, one fan not working..... perhaps the other is intermittent, i would be getting them checked out post haste, plugs are cheap, throw a set in as well see how it goes, the thermostat sounds like a good idea too.
mik is offline   Reply With Quote Multi-Quote with this Post
Old 04-04-2009, 09:33 PM   #4
Chamelion
FF.Com.Au Hardcore
 
Join Date: Sep 2007
Location: Scarness, Hervey Bay.
Posts: 830
Default

Cheers lads... How would I test the fans? Just throw in a new set from the wreckers and see what happens? :P

I'll do the plugs and thermostat at any rate.. I assume changing the thermostat isn't hard.

Matt.
Chamelion is offline   Reply With Quote Multi-Quote with this Post
Old 04-04-2009, 09:41 PM   #5
au2sw
Blown 5L coming
 
au2sw's Avatar
 
Join Date: Dec 2006
Location: Warwick, QLD
Posts: 1,997
Default

thermo is easy as, if you want, come round to my place with a new thremostat amd coolant, and we'll do a coolant flush and thermostat change. and ill have a look see to make sure everything else is ok for you matt. PM me if your interested
__________________
1995 EF Fairmont was stocko 6cyl with open single spin diff....NOW WITH XR8 ENGINE, DRIVELINE AND SUSPENSION!!!!! Maybe by the end of 2010 there may just be a blower as well ;)


NEW CLUB FOR SUNSHINE COAST !! www.f-p-e.proboards.com

Contact Col (au2sw) via PM or on MSN @ efmonty@hotmail.com

Quote:
Originally Posted by Mr Hardware
Its like central locking in your car. We've all had cars without it and we were fine then, but try and take it from me? NO WAY.
au2sw is offline   Reply With Quote Multi-Quote with this Post
Old 05-04-2009, 01:52 AM   #6
EvilChief
Boost Addict
 
Join Date: Jan 2005
Location: North Brisbane
Posts: 1,151
Default

idling rough: tighten intake manifold bolts
__________________
N12 Pulsar - sold
Gen1 Liberty Turbo - sold
VP Commodore Turbo - sold
LN65 Hilux Turbo - sold
EL31 Corolla Turbo - sold
Ford AU Ute Turbo - sold
Ford AU XR8 Sedan - 5.4l V8 Turbo (in the build)
Ford BA XR6T Ute - daily driver
Ford FG XR6T Sedan - cruiser

do you see a general trend? I DO

Can't live with it, can't live without it!
EvilChief is offline   Reply With Quote Multi-Quote with this Post
Reply


Forum Jump


All times are GMT +11. The time now is 07:32 PM.


Powered by vBulletin® Version 3.8.5
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Other than what is legally copyrighted by the respective owners, this site is copyright www.fordforums.com.au
Positive SSL