|
Welcome to the Australian Ford Forums forum. You are currently viewing our boards as a guest which gives you limited access to view most discussions and inserts advertising. By joining our free community you will have access to post topics, communicate privately with other members, respond to polls, upload content and access many other special features without post based advertising banners. Registration is simple and absolutely free so please, join our community today! If you have any problems with the registration process or your account login, please contact us. Please Note: All new registrations go through a manual approval queue to keep spammers out. This is checked twice each day so there will be a delay before your registration is activated. |
|
|
Thread Tools | Display Modes |
|
26-01-2013, 05:30 PM | #1 | ||
Dinosaur
Join Date: May 2010
Location: toowoomba QLD
Posts: 14
|
hi guy's,just wondering if there is a problem fitting a momo wheel from aTE-50 S2 to a 2001 au forte,dont think the auto buttons will work (wiring not there) just not sure about the spline on the shaft can get hold of a good wheel pretty cheap.thanks heaps cheers Gary.
|
||
26-01-2013, 06:07 PM | #2 | ||
Banned
Join Date: Dec 2012
Location: bed rock bottom
Posts: 31
|
There's no problem physically to fit the wheel - no spline though; just a square shaft.
|
||
27-01-2013, 12:15 AM | #3 | ||
FF.Com.Au Hardcore
Join Date: Aug 2006
Location: Salamander Bay
Posts: 5,427
|
the buttons will work fine if you use the normal clockspring and not the one from the TE 50
__________________
[SIGPIC][/SIGPIC]
Everyone starts off with a bag full of luck and an empty bag of experience. The trick is to fill the experience bag before the luck bag is empty. "It is better to remain silent and be thought a fool than to speak out and remove all doubt." Start a new career as a bus driver Rides: FG2 XR6 stock at this stage but a very nice ride xc 4 DOOR X CHASER 5.8 UNDER RESTO |
||
27-01-2013, 04:01 PM | #4 | ||
Dinosaur
Join Date: May 2010
Location: toowoomba QLD
Posts: 14
|
thanks for the info guy's will have a go
|
||