|
|
|
|
|
|
Welcome to the Australian Ford Forums forum. You are currently viewing our boards as a guest which gives you limited access to view most discussions and inserts advertising. By joining our free community you will have access to post topics, communicate privately with other members, respond to polls, upload content and access many other special features without post based advertising banners. Registration is simple and absolutely free so please, join our community today! If you have any problems with the registration process or your account login, please contact us. Please Note: All new registrations go through a manual approval queue to keep spammers out. This is checked twice each day so there will be a delay before your registration is activated. |
|
|||||||
 |
|
|
Thread Tools | Display Modes |
07-07-2005, 02:15 PM
|
#1 | ||
|
Guest
Posts: n/a
|
 : any info on tuning up a Laser KE 1.6L 1988 model would be much appreciated, thanks. |
||
|
|
16-01-2007, 09:19 PM
|
#2 | ||
|
Starter Motor
Join Date: Jan 2007
Posts: 2
|
timing info needed for 88 KE laser!!
|
||
|
|
|
16-01-2007, 10:06 PM
|
#3 | ||
|
Over Thinker
Join Date: Dec 2005
Location: Ipswich Qld
Posts: 1,351
|
pm vippin or another laser owner ..
should be a sticker ..with that info .. on the underside of the bonnet most of the roadside break down clubs have a free technical service you can phone that club during working hours if no one posts
__________________
My car goes Brumm Brumm |
||
|
|
|
|
24-03-2012, 10:36 AM
|
#4 | ||
|
Starter Motor
Join Date: Oct 2009
Posts: 8
|
Wether carb or injected the timing is the same. Put the rocker cover in place and the cam cog marks are at 3 o'clock with the top mark lined up with the mark on the cover. The crank cog has a cut out that lines up with the pointer at the rear. The tensioner should only bear on the belt with the spring tension. Make sure these marks are lined up with the right side of the belt taut.This info is for the 1.6 B6 engine.
|
||
|
|
|
|
| Thread Tools | |
| Display Modes | |
|
|
Timing info needed for '88 Laser KE 1.6
Linear Mode
