|
|
|
|
|
|
Welcome to the Australian Ford Forums forum. You are currently viewing our boards as a guest which gives you limited access to view most discussions and inserts advertising. By joining our free community you will have access to post topics, communicate privately with other members, respond to polls, upload content and access many other special features without post based advertising banners. Registration is simple and absolutely free so please, join our community today! If you have any problems with the registration process or your account login, please contact us. Please Note: All new registrations go through a manual approval queue to keep spammers out. This is checked twice each day so there will be a delay before your registration is activated. |
|
|||||||
| The Pub For General Automotive Related Talk |
 |
|
|
Thread Tools | Display Modes |
06-12-2014, 06:06 PM
|
#1 | ||
|
Starter Motor
Join Date: Dec 2014
Posts: 5
|
hello there I'm new here i have a damaged front reinforcement bar i thought they were a bolt on reo but its a wield job so my question is can i just grind the reo of myself and buy a new one and wield it on or its illegal and what do i have to look out for anything at all when i do it..
THANKS in advance any replies would be appreciated the car is: 2004 BA MK2 XR6 |
||
|
|
|
06-12-2014, 07:40 PM
|
#2 | ||
|
FF.Com.Au Hardcore
Join Date: May 2009
Posts: 1,013
|
hi crash,,i asked the same question about 2 years ago,,,,following is a response i received from a fellow forum member who is a panel beater/spray painter
"Ahh that is hi strength steel so they must be spot welded on to comply with the air bag sensor. You can not mig tig or oxy any where near that item. The rail ends are hi strength steel as well. If you hit it with to much heat the whole lot will distort. I'm a panel beater and do them all week long. But i guess its you car and your safety" the part is around $120 i think |
||
|
|
|
| 2 users like this post: |
2004 xr6 reo
Linear Mode
