Extractor Fitment

[JL]

Got my Lukey exhuast fitted to the AUII I purchased from the last group buy. Sounds real nice, but haven't got my extractors fitted yet because it needs a bit of mucking around with welding the flanges to the cat.

Now, I went to the local exhuast place to ask them how much would it be to fit the extractors on to match the existing cat. They turned around and said that it can not be done, I will need to purchase a new cat so they can weld the matching flange to the extractors (I have the gasket & flange to fir extractors). This will cost around $300 for the cat and about $150 for labour.

I have read everywhere on here about the AUII cat is sufficient so no need to go for a new cat. Plus the cat is a low k cat anyways... I suggested that they could just take a short length of pipe and weld that flange on and then weld it to the cat... The guy told me no, its not possible...

So can someone tell me, where can I go around the Bankstown area to get my extractors fitted without having to buy a new cat. I mean i'm budgeting $150 for the fitting with a set of nice twin tips as well.