|
|
|
|
|
|
Welcome to the Australian Ford Forums forum. You are currently viewing our boards as a guest which gives you limited access to view most discussions and inserts advertising. By joining our free community you will have access to post topics, communicate privately with other members, respond to polls, upload content and access many other special features without post based advertising banners. Registration is simple and absolutely free so please, join our community today! If you have any problems with the registration process or your account login, please contact us. Please Note: All new registrations go through a manual approval queue to keep spammers out. This is checked twice each day so there will be a delay before your registration is activated. |
|
|||||||
|
|
Thread Tools | Display Modes |
14-06-2007, 09:25 PM
|
#1 | ||
|
www.TUFFCARPARTS.com
Join Date: Feb 2006
Posts: 5,221
|
Hi All,
Getting someone to fit my extractors for me, but they seem to think you need to know the torque reading for the exhaust bolts to the head. I'm pretty much positive, you just tighten up as much as you can (it's not like it's a head gasket or anything), but can anyone confirm or deny this either way? When I bolted my last set of extractors on myself, this is all I did (ie just did them as tight as possible, no torque readings...), and the car was fine.... By the way, it's Pacemaker 4499's going onto an I6. Thanks, Justin.
__________________
http://i1233.photobucket.com/albums/...psc203b7b1.jpg |
||
|
|
Bolting on extractors - is a torque wrench required?
Threaded Mode