|
|
|
|
|
|
Welcome to the Australian Ford Forums forum. You are currently viewing our boards as a guest which gives you limited access to view most discussions and inserts advertising. By joining our free community you will have access to post topics, communicate privately with other members, respond to polls, upload content and access many other special features without post based advertising banners. Registration is simple and absolutely free so please, join our community today! If you have any problems with the registration process or your account login, please contact us. Please Note: All new registrations go through a manual approval queue to keep spammers out. This is checked twice each day so there will be a delay before your registration is activated. |
|
|||||||
|
|
Thread Tools | Display Modes |
22-11-2007, 12:03 PM
|
#1 | ||
|
Rated G
Join Date: Dec 2006
Location: The Hills
Posts: 177
|
Howdy doody all
a cursory glance at the discs and pads on my WP Zetec reveals that it's probably time for a replacement. The original set have seen me through for near on 90K km and I'm quite happy with that. A couple of obvious questions arise though, and I'm sure that there are obvious answers... 1. Can the discs be machined? 2. If so, is it worthwhile? 3. What is the minimum disc thickness? 4. Can anyone recommend good aftermarket discs to use? Factors are improved braking without harshness, disc / pad life and cost. As a side note, I am going to try either Ferrodo or EBC Greenstuff pads. Cheers Ali. |
||
|
|
Brakes - Discs and pads
Threaded Mode