|
|
|
|
|
|
Welcome to the Australian Ford Forums forum. You are currently viewing our boards as a guest which gives you limited access to view most discussions and inserts advertising. By joining our free community you will have access to post topics, communicate privately with other members, respond to polls, upload content and access many other special features without post based advertising banners. Registration is simple and absolutely free so please, join our community today! If you have any problems with the registration process or your account login, please contact us. Please Note: All new registrations go through a manual approval queue to keep spammers out. This is checked twice each day so there will be a delay before your registration is activated. |
|
|||||||
|
|
Thread Tools | Display Modes |
13-03-2012, 06:53 PM
|
#1 | ||
|
Lacking Imagination
Join Date: Jul 2006
Location: In The Global Collective
Posts: 3,909
|
Hey guys,
as some may know, i have a Post 7/99 AU1 Fairlane that has Smartshield. Now my question is that I recently had a AU2 XR6 ECU Programmed to the car, and the car was stalling, when i had the codes read, it said that there was no communication to the T-MAP Sensor and some other sensors, now, is there a difference in the wiring loom for the AU1 Vs AU2? Also would an AU2 Loom work into an AU1 as I am also looking at swapping over the entire dash loom as there are a few electrical gremlins i am trying to solve (e.g. ECU Recongising a CID Failure Mode). Nathan
__________________
My 11 Second AU Fairlane 364w | 225cc CNC | ---/---@0.050 | Morrison Motorsport ITB Manifold | MoTeC M150 (Engine Control) | PCS TCM-2800 (Trans Control) | 6800rpm Stall | 4R75W |
||
|
|
AU1 & AU2 - Engine Wiring Differences
Threaded Mode