|
|
|
|
|
|
Welcome to the Australian Ford Forums forum. You are currently viewing our boards as a guest which gives you limited access to view most discussions and inserts advertising. By joining our free community you will have access to post topics, communicate privately with other members, respond to polls, upload content and access many other special features without post based advertising banners. Registration is simple and absolutely free so please, join our community today! If you have any problems with the registration process or your account login, please contact us. Please Note: All new registrations go through a manual approval queue to keep spammers out. This is checked twice each day so there will be a delay before your registration is activated. |
|
|||||||
|
|
Thread Tools | Display Modes |
18-06-2013, 11:17 AM
|
#1 | ||
|
Q - CAR
Join Date: May 2011
Location: Central Coast ..
Posts: 746
|
Hi - recently installed new engine after a 7 month wait and i can not remember where this sensor goes.
In the image the sensor is draped over the radiator hose and has green tape to highlight. It comes off the injector harness at the same place where the cam positioning sensor, Timing sensor and started motor sensor are located. ... meaning there is 4 wires branching off at the same place. Can someone tell what the 4th is ??? 1 -Cam positioning 2- Timing 3- Starter motor 4 -  ???
__________________
AU FORD STROKER 347 Windsor Stroked; (10:2.1) / TFS 190 heads / TFS R Series 90 manifold / Accufab 85mm Race TB / 90mm Lightening MAF / K&N 90mm pod CAI / FTI custom cam (230-236 @ 50) / Bosch 36lb inject / MSD coil + leads / ASR 8lt sump / Mcleod RST Twin Plate Clutch / Pacemakers PH4006 + 3" single exhaust / BA Premium brake pac / Pedders Xtreme coil over shocks / 30mm Whiteline sway / 3.45 LSD / Custom FG bonnet / Ghia interior upgrade / Enkie Rims - staggered / Quarter Horse tuned. Last edited by bluestripes; 28-06-2013 at 06:03 PM. |
||
|
|
wiring harness sensor help - Au V8
Threaded Mode