|
|
|
|
|
|
Welcome to the Australian Ford Forums forum. You are currently viewing our boards as a guest which gives you limited access to view most discussions and inserts advertising. By joining our free community you will have access to post topics, communicate privately with other members, respond to polls, upload content and access many other special features without post based advertising banners. Registration is simple and absolutely free so please, join our community today! If you have any problems with the registration process or your account login, please contact us. Please Note: All new registrations go through a manual approval queue to keep spammers out. This is checked twice each day so there will be a delay before your registration is activated. |
|
|||||||
|
|
Thread Tools | Display Modes |
18-01-2019, 08:28 PM
|
#1 | ||
|
Starter Motor
Join Date: Mar 2016
Location: Feilding NZ
Posts: 2
|
Hi guys, looking at replacing my rear brake pads, discs don't need doing.
I have been doing lots of research here and on YouTube. My question is ,when winding in the piston, am I best to crack open the bleader, or take the lid off the master cylinder? Seems to be a lot of debate about dirty fluid getting into the ABS unit if it is done by taking the master cylinder top off and pushing the fluid up through the lines. I will also flush the fluid after doing the pads. Do I start at the left rear, then right rear, left front ,right front, like in the old days? Any help greatly appreciated. |
||
|
|
2012 mondeo rear brake pad replacement
Threaded Mode