MB Hatch Centre High Brake Light - segment blown

[cobrin]

The missus backs the vehicle out of the garage and I spot the middle segment of the Centre Brake light on the boot has gone out, two segments either side of it are working but it looks a bit low rent with the middle out. So today I go and investigate.

Of all my documents on the Mondeo I remember finding a 'how to remove the rear hatch trim' first and do you think I went to go look for it....Nup lol

It's as simple as it gets two phillips screws inside the grab handles and then you rip it off the hatch as the clips finally give out and break free.

Through one of the openings you can see the backside of the light assembly and disconnect the harness connection to it.

Next you'll see two of the lower silver clips at either end of the light assembly, you need to pinch inwards both lower and top side of those clips to push that side of the light outwards of it's hole. When that is done pinch the other end and push the light out completely.

Now go to a bench and have a look it. Surprisingly it's not an LED arrangement, there are 5 W5W bulbs and my middle one has blown. To separate the red lens from the reflector to access the bulbs you need to look at the silver clips again.

This time you're looking at the other end of them and how it has a little tongue that bends back around (from between the housing and red lens) and clamps to the red lens portion. I used a small jewellers flat blade and raised that tongue a little to release the red lens on all 4 clips and it slides apart. No need to completely remove it, the red lens stops about 2.5cm which is enough to pinch each bulb and remove them.

I figure I've had my monies worth out of them so I replace them all (3pks of two W5W bulbs) that leaves spares for whenever...

Slide the red lens back down,bend that tongue bit back over and you're done.

Push the brake light assembly back into the hole, connect the harness and test it using a gorgeous assistant.

Snap in the trim piece and fix it down with the screw in each grab handle and you're done.

Sorry for the no photos, it really is that easy and only took minutes to do. End result is a fresh bright looking brake light (all the way across).