|
|
|
|
|
|
Welcome to the Australian Ford Forums forum. You are currently viewing our boards as a guest which gives you limited access to view most discussions and inserts advertising. By joining our free community you will have access to post topics, communicate privately with other members, respond to polls, upload content and access many other special features without post based advertising banners. Registration is simple and absolutely free so please, join our community today! If you have any problems with the registration process or your account login, please contact us. Please Note: All new registrations go through a manual approval queue to keep spammers out. This is checked twice each day so there will be a delay before your registration is activated. |
|
|||||||
| The Pub For General Automotive Related Talk |
|
|
Thread Tools | Display Modes |
29-06-2021, 09:08 PM
|
#1 | ||
|
FF.Com.Au Hardcore
Join Date: Mar 2012
Posts: 963
|
https://www.grays.com/lot/0001-77911...EUtIQMqrZTa4C0
I'm not sure how this thing escaped the clutches of Ford Aus. It is a December 2007 FG G6E Turbo Prototype! It appears there is some issue with the compliance plate decal, as the computer chucked a wobbly when the car came down the line ready to receive it. It might have had a proper label attached on top and then later removed. The paint in the door jam near the stickers appears to be redone very poorly with massive tape edges. Just looking at the engine bay I can see several anomalies against production vehicles - - Plastic intake muffler delete pipe with host joiner locater (pre-pro part) - Difference in the crossover to airbox pipe - Clamps on BOV aren't spring type - Thermostat housing has relief pipe to header - PCM looks thicker? Very interesting stuff.. Last edited by FPV414; 29-06-2021 at 09:26 PM. Reason: Incorrect link |
||
|
|
| 5 users like this post: |
FG Prototype at Grays Online
Threaded Mode