|
|
|
|
|
|
Welcome to the Australian Ford Forums forum. You are currently viewing our boards as a guest which gives you limited access to view most discussions and inserts advertising. By joining our free community you will have access to post topics, communicate privately with other members, respond to polls, upload content and access many other special features without post based advertising banners. Registration is simple and absolutely free so please, join our community today! If you have any problems with the registration process or your account login, please contact us. Please Note: All new registrations go through a manual approval queue to keep spammers out. This is checked twice each day so there will be a delay before your registration is activated. |
|
|||||||
| The Bar For non Automotive Related Chat |
|
|
Thread Tools | Display Modes |
14-10-2021, 10:26 PM
|
#1 | ||
|
DIY Tragic
Join Date: Apr 2018
Location: Sydney, more than not. I hate it.
Posts: 22,631
|
What I want to do: Trace back circuits on a two-sided SMD board.
It’s all but impossible to follow them by eye, due to multi-way connectors soldered over parts of the circuits. Is it safe to carefully probe back? I’ve looked at some of the semiconductor specs and they seem quite tolerant of boofheadry. Most of the lines I want to trace use an applied ground as a signal. Once I have a good clue on a single circuit, I only need to confirm by following back a couple of others. |
||
|
|
Autoranging DMM Probe Power
Threaded Mode