|
|
|
|
|
|
Welcome to the Australian Ford Forums forum. You are currently viewing our boards as a guest which gives you limited access to view most discussions and inserts advertising. By joining our free community you will have access to post topics, communicate privately with other members, respond to polls, upload content and access many other special features without post based advertising banners. Registration is simple and absolutely free so please, join our community today! If you have any problems with the registration process or your account login, please contact us. Please Note: All new registrations go through a manual approval queue to keep spammers out. This is checked twice each day so there will be a delay before your registration is activated. |
|
|||||||
 |
|
|
Thread Tools | Display Modes |
21-12-2008, 11:47 AM
|
#1 | ||
|
Starter Motor
Join Date: Dec 2008
Location: Perth
Posts: 5
|
Hi guys am new here. I'm wanting to change stop/tail light globe but cant seem to remove the tail light assembly to get at globe. Any advice would be greatly appreciated.
|
||
|
|
|
21-12-2008, 10:21 PM
|
#2 | ||
|
Regular Member
Join Date: Nov 2007
Location: Liverpool, NSW
Posts: 278
|
On the WQ you just under the bolts and it slides off. I'm not sure about the WP tho. It doesnt say in the manual?
__________________
2006 WQ Fiesta Zetec Sea Grey Interior:- MOMO Blue Leather Gear Knob, Window tint, Scuff Plates, ST Black & Blue Leather seats, Soundstream Amp & 5x7 speakers, Sony Headunit, Pioneer sub & Amp. Under the Hood:- Superchips ECU Flash Tune, Denso Iridium plugs, KV85 Magnecor Leads, BMC CDA Induction. Exterior:- Spoiler, clear side repeaters, Lowered (35mm) King Springs, Whiteline 22mm Rear sway bar, 2" cat back exhaust with a dual conversion, Konig 17" Hotswap with Kumho Rubber, HID's. |
||
|
|
|
|
22-12-2008, 12:49 AM
|
#3 | ||
|
Starter Motor
Join Date: Dec 2008
Location: Perth
Posts: 5
|
I've taken out the 2 holding screws but no amount of reasonable force will remove the tail light. Not keen on forcing it too much in case something breaks. It seems like there is something else holding it there.
|
||
|
|
|
|
22-12-2008, 01:05 AM
|
#4 | ||
|
Regular Member
Join Date: Jun 2007
Posts: 175
|
if its the wp, i had the same problem with my sisters fiesta wanted to shred it into peices, if you look at the light from the inside of the boot you can flip abit of the carpet off, there a black plastic screw on part, no screwdriver needed, just turn it with your fingers and they come out right away.
|
||
|
|
|
|
22-12-2008, 08:32 PM
|
#5 | ||
|
Starter Motor
Join Date: Dec 2008
Location: Perth
Posts: 5
|
Thanks fiesta8u. All fixed now.
|
||
|
|
|
|
23-12-2008, 07:35 PM
|
#6 | ||
|
Regular Member
Join Date: Jun 2007
Posts: 175
|
no worries mate.
|
||
|
|
|
|
| Thread Tools | |
| Display Modes | |
|
|
Removal of tail light assembly on WP
Linear Mode
