|
|
|
|
|
|
Welcome to the Australian Ford Forums forum. You are currently viewing our boards as a guest which gives you limited access to view most discussions and inserts advertising. By joining our free community you will have access to post topics, communicate privately with other members, respond to polls, upload content and access many other special features without post based advertising banners. Registration is simple and absolutely free so please, join our community today! If you have any problems with the registration process or your account login, please contact us. Please Note: All new registrations go through a manual approval queue to keep spammers out. This is checked twice each day so there will be a delay before your registration is activated. |
|
|||||||
 |
|
|
Thread Tools | Display Modes |
23-04-2019, 12:34 AM
|
#1 | ||
|
Starter Motor
Join Date: Oct 2016
Location: Perth
Posts: 17
|
Have a mk 2 Escort and had a Cosworth YB built for it. Used the "How to Power Tune Ford SOHC" by Des Hammill for guidance on the various bits and pieces required (has a YB conversion chapter). Have just finished adding on the necessary accessories, eg sender units, dizzy, manifolds, flywheel, clutch, etc.
Went to bolt the Rocket gearbox on and noticed the ring gear runs extremely close to the bellhouse (within 1mm). Is this normal? Everything I have read indicates the flywheel and clutch are larger between the Pinto and the YB, but nothing suggested regarding changing the flywheel. Likewise, have not read anything anywhere that indicates the bellhouse should not fit. Am I missing something somewhere? Cheers
__________________
If in doubt, throttle out.... 2020 Mustang R-spec (#013) 2016 Ranger PXII XLT 2008 Porsche 911 GT2 1976 Escort mk2 Cosworth race car |
||
|
|
|
| Thread Tools | |
| Display Modes | |
|
|
Cosworth YB install query
Linear Mode
