|
|
|
|
|
|
Welcome to the Australian Ford Forums forum. You are currently viewing our boards as a guest which gives you limited access to view most discussions and inserts advertising. By joining our free community you will have access to post topics, communicate privately with other members, respond to polls, upload content and access many other special features without post based advertising banners. Registration is simple and absolutely free so please, join our community today! If you have any problems with the registration process or your account login, please contact us. Please Note: All new registrations go through a manual approval queue to keep spammers out. This is checked twice each day so there will be a delay before your registration is activated. |
|
|||||||
 |
|
|
Thread Tools | Display Modes |
23-06-2008, 07:21 AM
|
#1 | ||
|
FF.Com.Au Hardcore
Join Date: Dec 2004
Location: hunter valley
Posts: 1,925
|
What is the correct torque to do the nut up to on the front au wheel bearings?
Cheers |
||
|
|
|
23-06-2008, 09:39 AM
|
#2 | ||
|
FF.Com.Au Hardcore
 
Join Date: Nov 2007
Location: Riff
Posts: 12,400
|
__________________
FGII XR6 IN LIGHTNING STRIKE R52 SIII IN GUN METALLIC |
||
|
|
|
|
23-06-2008, 10:19 AM
|
#3 | ||
|
FF.Com.Au Hardcore
Join Date: Dec 2004
Location: hunter valley
Posts: 1,925
|
thanks mate. it says on the torque it to 255-354nm. What is the right setting?
|
||
|
|
|
|
23-06-2008, 10:26 AM
|
#4 | ||
|
FF.Com.Au Hardcore
Join Date: Nov 2007
Location: Riff
Posts: 12,400
|
found better info: 13.Install new hub by sliding onto shaft. Apply Loctite or similar to thread and tighten hub nut with tension wrench to 305Nm (225 lbs ft)
__________________
FGII XR6 IN LIGHTNING STRIKE R52 SIII IN GUN METALLIC |
||
|
|
|
|
| Thread Tools | |
| Display Modes | |
|
|
wheel bearings
Linear Mode
