|
|
|
|
|
|
Welcome to the Australian Ford Forums forum. You are currently viewing our boards as a guest which gives you limited access to view most discussions and inserts advertising. By joining our free community you will have access to post topics, communicate privately with other members, respond to polls, upload content and access many other special features without post based advertising banners. Registration is simple and absolutely free so please, join our community today! If you have any problems with the registration process or your account login, please contact us. Please Note: All new registrations go through a manual approval queue to keep spammers out. This is checked twice each day so there will be a delay before your registration is activated. |
|
|||||||
 |
|
|
Thread Tools | Display Modes |
06-08-2010, 09:35 PM
|
#1 | ||
|
Only an xr6...
Join Date: May 2005
Location: Brisbane
Posts: 539
|
Hi all, Feel like debadging my ute tomorrow whilst doing other stuff, but I heard the ford badge on the rear has two holes behind it just wondering if there's an easy way to patch these. Or do I have to bite the bullet and respray the tailgate?.
|
||
|
|
|
06-08-2010, 09:39 PM
|
#2 | ||
|
Regular Member
Join Date: May 2006
Location: Mandurah, WA
Posts: 80
|
There are two holes behind the ford badge and the falcon badge as well.
I removed the falcon badge from mine without knowing, and ended up using a little silastic to fill the holes to stop water getting in, then a carefull dab with some touch-up paint and a polish and it was barely noticable, i have since had the holes filled and tailgate re-sprayed though |
||
|
|
|
|
06-08-2010, 09:53 PM
|
#3 | ||
|
Only an xr6...
Join Date: May 2005
Location: Brisbane
Posts: 539
|
well if thats the case I might as well save and get a pro to do it cause I want to get rid of the door moulds as well.
|
||
|
|
|
|
06-08-2010, 10:14 PM
|
#4 | ||
|
FF.Com.Au Hardcore
Join Date: Apr 2009
Location: jimboomba
Posts: 4,638
|
Should try and fit the ba moulds on the doors as there more flatter then the au ones
__________________
Welder/Fabricator at Beaudesert Exhuast Posted by Xcabbi, Does it slap or rattle? Rattle is more to do with timing chains and tensioners. Slap is more to do with lifters, rings, bearings or GENIII boat anchors |
||
|
|
|
|
06-08-2010, 10:51 PM
|
#5 | ||
|
Only an xr6...
Join Date: May 2005
Location: Brisbane
Posts: 539
|
Yeah that is the alternative if the getting rid of them all together is too expensive. Saw it done to a black ute at a ford show and looked fantastic, I've hated my door moulds since.
|
||
|
|
|
|
| Thread Tools | |
| Display Modes | |
|
|
Debadging AU ute
Linear Mode
