|
|
|
|
|
|
Welcome to the Australian Ford Forums forum. You are currently viewing our boards as a guest which gives you limited access to view most discussions and inserts advertising. By joining our free community you will have access to post topics, communicate privately with other members, respond to polls, upload content and access many other special features without post based advertising banners. Registration is simple and absolutely free so please, join our community today! If you have any problems with the registration process or your account login, please contact us. Please Note: All new registrations go through a manual approval queue to keep spammers out. This is checked twice each day so there will be a delay before your registration is activated. |
|
|||||||
 |
|
|
Thread Tools | Display Modes |
02-11-2011, 07:25 PM
|
#1 | ||
|
Starter Motor
Join Date: Sep 2011
Posts: 12
|
my auIII has what seems to be a stuffed clockspring. the radio control, cruise control, horn dont work and the airbag warning light is on. it flashes 3 times, then 2, the 3, then 2 etc, and then finally stays on. i have taken off the airbag, but i cant disconnect the plug from the clockspring connector. what is the trick?? i have disconnected the plugs down the bottom of the steering column to be able to test the wires for continuity through the clockspring, but the only wire with continuity is the earth wire.
|
||
|
|
|
02-11-2011, 10:33 PM
|
#2 | ||
|
Bugger!
Join Date: Jul 2011
Location: Albany, WA
Posts: 3,307
|
Spray silicone is a wonderful thing for sticky plugs
__________________
Whoops, there goes another factory setup! Chop and change - butchering cars since 1990 
|
||
|
|
|
|
04-11-2011, 03:46 PM
|
#3 | ||
|
Starter Motor
Join Date: Sep 2011
Posts: 12
|
sorted it out. the plug doesn`t come out of the clockspring does it... no. i found that out eventually.i got the clockspring out, pulled it apart, cut off the crook end and soldered it back together. all fixed. it was a bit fiddly though, keeping all the soldered joints separated, but only took about an hour to pull apart and rebuild.fine tipped soldering iron is a must. the bit i had the most trouble with was pulling the steering wheel off. they must have assembled it originally with shaft-fit loctite. anyway, it`s all good now, everything works like it should.
|
||
|
|
|
|
| Thread Tools | |
| Display Modes | |
|
|
suspect clockspring
Linear Mode
