|
|
|
|
|
|
Welcome to the Australian Ford Forums forum. You are currently viewing our boards as a guest which gives you limited access to view most discussions and inserts advertising. By joining our free community you will have access to post topics, communicate privately with other members, respond to polls, upload content and access many other special features without post based advertising banners. Registration is simple and absolutely free so please, join our community today! If you have any problems with the registration process or your account login, please contact us. Please Note: All new registrations go through a manual approval queue to keep spammers out. This is checked twice each day so there will be a delay before your registration is activated. |
|
|||||||
 |
|
|
Thread Tools | Display Modes |
06-12-2006, 05:30 PM
|
#1 | ||
|
Starter Motor
Join Date: Sep 2006
Posts: 26
|
Hi Everyone,
I treated my 'good lady' to a 2004 Zetec Auto a few months ago and although she is very pleased with the car, it has a niggling problem on start-up. On the initial start in the mornings, the engine speed is 'hunting', therefore when you select 'Drive' or 'Reverse' the car jumps about for the first 20-30 seconds and then it's fine. Any ideas would be much appreciated. Thanks in advance, Mike |
||
|
|
|
06-12-2006, 05:38 PM
|
#2 | ||
|
FF.Com.Au Hardcore
Join Date: May 2006
Location: Sydney, NSW
Posts: 2,368
|
What do you mean by "the engine speed is hunting"? When I start my car in the morning it normally idles at 1000rpm for about 1 min or so, and then goes back to 750rpm.
But even if I was in a hurry, my car didnt "jump" when I select "R". Maybe bad fuel? |
||
|
|
|
|
06-12-2006, 06:22 PM
|
#3 | ||
|
Starter Motor
Join Date: Sep 2006
Posts: 26
|
The idle speed flicks between 1400 and 1000, hence causing the car to kangaroo down the street when no gas applied!
Already been to Ford dealer...they're as much use as a "handbrake on a canoe"!!! Cheers, Mike |
||
|
|
|
|
06-12-2006, 09:08 PM
|
#4 | ||
|
Non-Regular Member
Join Date: Oct 2006
Posts: 1,040
|
Could simply be a ECU issue. Reflash the ECU it sounds like a Cold enrichment and idle speed calibration issue.
|
||
|
|
|
|
06-12-2006, 11:20 PM
|
#5 | ||
|
LPG > You
Join Date: Dec 2004
Location: Sydney, NSW, Australia
Posts: 4,277
|
When I start my car (05 Zetec WP), it sits at 1250rpm while the temp gauge is on stone cold. Does this for about 2 min. Temp gauges jumps up, slows itself down to 1000rpm, then eases down to its normal 750rpm idle.
__________________
LPG Lovers Association President & Member #1.  : 
|
||
|
|
|
|
07-12-2006, 12:26 AM
|
#6 | ||
|
FF.Com.Au Hardcore
Join Date: Apr 2005
Location: Canberra
Posts: 13,436
|
Air Flow Meter possibly? RPM hunting can sometimes be caused by a faulty AFM.
|
||
|
|
|
|
07-12-2006, 12:46 AM
|
#7 | ||
|
Non-Regular Member
Join Date: Oct 2006
Posts: 1,040
|
Fiesta uses MAP sensor
|
||
|
|
|
|
07-12-2006, 12:56 AM
|
#8 | |||
|
FF.Com.Au Hardcore
Join Date: Apr 2005
Location: Canberra
Posts: 13,436
|
Quote:
|
|||
|
|
|
Zetec Start up Problem
Linear Mode
