lsd changing

[eb91xr6]

hey guys

im building a new diff for my car im using a LSD from a Fairlane, it had 3.27lsd, i have fitted it to my car bit have one problem. the left side axel wont go in it stopes around 20mm to far out of the diff. has anyone changed rrom a 3.23 openwheeler center to a Fairlane center as i would love to get this diff in my car asap only issue is that the axel dosnt go in fully, there both 28 spline and all i have changed is the center, the crown to my old one and thats it went to put the axels back in but only one side goes in but the RL dosnt,

only thing i could thing of is
1, the axels are different on the non lsd to LSD
2, fairlane centers done fit EB s1 diffs
3, abs could be an issue,

any info would be great,

[eb91xr6]

bump some one must know wtf is wrong with it

[LTDHO]

So you used the Fairlane LSD centre and gears?
Which housing?
Have you checked the splines?

Oh and if you put this in the tech section not general, then you would get more responses.

[eb91xr6]

if a mod could move it that would be great

there out of a fairlane and the current diff are 28 spline im using the fairlane center, the current gears in a EB gli diff, is there any reason for it not to fit the long side does but the short side dosnt fit by 20mm just wont go in

[poomba]

are you using the right axel in the right side??

[eb91xr6]

yep
didnt remove them just pulled them out 100mm so i could get the center out,

[eb91xr6]

theres the side that dosnt go in and the center with my original gears on it and the rl has a abs axel and the rr has a non abs but fits