Replacing two lights

[Riksta]

Originally Posted by ronwest

No, you're right as far as the size goes - I was getting my cluster globes and my switch globes all kerfumbled.

The switch globes are removable from the holder. Its a matter of unwinding the "leg" on each side (+ and -). To install led's you solder a resister onto the + and wind the legs on

Here's a pic of the smaller led showing it "unwound"

They look the same as the Odometer globes I mentioned earlier, where the holder and the globe are supposedly "one piece" but can be separated.

Although, they may be a different size or something.

Edit - they're on the 7th page of this PDF (or page 101 if you go by the page numbers at the bottom) - http://media.narva.com.au/books/4.pdf

[ronwest]

Originally Posted by Riksta

They look the same as the Odometer globes I mentioned earlier, where the holder and the globe are supposedly "one piece" but can be separated.

Although, they may be a different size or something.

Edit - they're on the 7th page of this PDF (or page 101 if you go by the page numbers at the bottom) - http://media.narva.com.au/books/4.pdf

Yeah, the odo and switch globes/holders are the same. If you change the odo globes to led's you can mount the resister externally. With the switches there's no room and you have to squeeze them inside the housing.
I've got a pic somewhere, I'll try to find it later.

The catalogue is a nice find