|
|
|
|
|
|
Welcome to the Australian Ford Forums forum. You are currently viewing our boards as a guest which gives you limited access to view most discussions and inserts advertising. By joining our free community you will have access to post topics, communicate privately with other members, respond to polls, upload content and access many other special features without post based advertising banners. Registration is simple and absolutely free so please, join our community today! If you have any problems with the registration process or your account login, please contact us. Please Note: All new registrations go through a manual approval queue to keep spammers out. This is checked twice each day so there will be a delay before your registration is activated. |
|
|||||||
 |
|
|
Thread Tools | Display Modes |
23-01-2010, 06:09 PM
|
#1 | ||
|
love my eb,s
Join Date: Nov 2008
Location: holmview
Posts: 263
|
replacing my head gasket and looking for the head bolt torc seting and eny info i may need lol
|
||
|
|
|
23-01-2010, 07:47 PM
|
#2 | ||
|
Chairman & Administrator
  
Join Date: Dec 2004
Location: 1975
Posts: 107,234
|
The Duratec 1.8 and 2.0 are as follows:
Tighten the cylinder head bolts (in sequence) in five stages: • Stage 1: 5 Nm. • Stage 2: 15 Nm. • Stage 3: 45 Nm. • Stage 4: 90 degrees. • Stage 5: 90 degrees. The sequence starts from the centre pair of bolts and works outward and on opposite sides. That is to say Centre LH, Centre RH. 1 back from centre (left and right) then 1 forward from centre (left and right) until completed. The earlier 1.6-2.0 Zetec engines are tightened using the same order but to these specs: Stage 1: 20 Nm Stage 2: 40 Nm Stage 3: 90 degrees Please note that in some Zetec applications the Stage 3 tightening is to 105 degrees Cheers Russ
__________________
 Observatio Facta Rotae
Last edited by russellw; 23-01-2010 at 07:57 PM. |
||
|
|
|
|
24-01-2010, 08:31 AM
|
#3 | ||
|
Starter Motor
Join Date: Jul 2009
Posts: 26
|
Since its a 1997 Mondeo, the engine would be the silver top (early) Zetec - not Duratec.
|
||
|
|
|
|
24-01-2010, 09:06 AM
|
#4 | ||
|
love my eb,s
Join Date: Nov 2008
Location: holmview
Posts: 263
|
its the 1.6
|
||
|
|
|
1997 mondeo head bolt torc setings
Linear Mode
