Welcome to the Australian Ford Forums forum.

You are currently viewing our boards as a guest which gives you limited access to view most discussions and inserts advertising. By joining our free community you will have access to post topics, communicate privately with other members, respond to polls, upload content and access many other special features without post based advertising banners. Registration is simple and absolutely free so please, join our community today!

If you have any problems with the registration process or your account login, please contact us.

Please Note: All new registrations go through a manual approval queue to keep spammers out. This is checked twice each day so there will be a delay before your registration is activated.

Go Back   Australian Ford Forums > Club and Speciality Forums > Forum Community Car Clubs > AU Falcon.com.au

Reply
 
Thread Tools Display Modes
Old 03-05-2010, 05:18 PM   #1
rosebush
Regular Member
 
rosebush's Avatar
 
Join Date: Nov 2009
Location: Sunshine Coast QLD
Posts: 53
Default DTE & Fuel Gauge reading empty with full tank

My DTE and fuel guage keeps reading empty even after half filling the tank. Its like its stuck on Zero and beeps all the time.
Im assuming it has something to do with removing the boot carpet as it started straight after we did this.
This has happened in the past a couple of years ago (Again from removing the carpet) but then just one day fixed itself????
Any ideas please on where to start? Thanks

rosebush is offline   Reply With Quote Multi-Quote with this Post
Old 03-05-2010, 05:23 PM   #2
GS608
FF.Com.Au Hardcore
 
Join Date: Feb 2007
Location: ...in the shed
Posts: 3,386
Default

Welcome to the world of Ford electronics..mine quite often doesn't register when i fill it up and keeps going with the low range and fuel light, has only happened when i put $20 or so in it though.
GS608 is offline   Reply With Quote Multi-Quote with this Post
Old 03-05-2010, 05:24 PM   #3
Riksta
Captain Malcolm Reynolds
 
Riksta's Avatar
 
Join Date: Mar 2007
Location: Adelaide
Posts: 3,830
Default

Quote:
Originally Posted by XR-CHIEF
Welcome to the world of Ford electronics..mine quite often doesn't register when i fill it up and keeps going with the low range and fuel light, has only happened when i put $20 or so in it though.
But in this day & age would $20 of fuel even move the gauge up at all?
__________________
Currently: 2014 Mazda6 GT (Daily) and 1999 Mazda MX5 (Fun Car)
Previously: 2001 Ford Escape XLT; 2010 MC Mondeo; 1984 FD LTD; 2001 AU2 Falcon Forte; 2005 LS Focus Zetec; 1988 RE Colt; 1982 RB Colt; 1974 KE20 Corolla
Quote:
Originally Posted by Nikked
Riksta likes VN's so much, he has the ashes of a VN in a jar on the mantle piece, a vile of VN engine oil hanging from his neck and a BT1 build plate locked up in a safe, buried under 6ft of concrete.
Quote:
Originally Posted by Day-mow
pretty much what has happened here is i trolled you. and it was fun.
Riksta is offline   Reply With Quote Multi-Quote with this Post
Old 03-05-2010, 05:28 PM   #4
rosebush
Regular Member
 
rosebush's Avatar
 
Join Date: Nov 2009
Location: Sunshine Coast QLD
Posts: 53
Default

I put in $40 (Half tank about) but still didnt move surly thats enough to do do something??
rosebush is offline   Reply With Quote Multi-Quote with this Post
Old 03-05-2010, 05:29 PM   #5
frd906
FF.Com.Au Hardcore
 
Join Date: Apr 2009
Location: jimboomba
Posts: 4,638
Default

Noticed mine does the same thing, my dte reads at 80 when it shows quarter of a tank, which it usually registers at 200, cluster must be on its way out
__________________
Welder/Fabricator at Beaudesert Exhuast

Posted by Xcabbi, Does it slap or rattle? Rattle is more to do with timing chains and tensioners. Slap is more to do with lifters, rings, bearings or GENIII boat anchors
frd906 is offline   Reply With Quote Multi-Quote with this Post
Old 03-05-2010, 05:39 PM   #6
rosebush
Regular Member
 
rosebush's Avatar
 
Join Date: Nov 2009
Location: Sunshine Coast QLD
Posts: 53
Default

Mine registered at Zero at all times....It must have something to do with removing the carpet, is there a switch or something that could of come loose in the boot? This is what happened last time...Just dont know how it fixed itself...
rosebush is offline   Reply With Quote Multi-Quote with this Post
Old 04-05-2010, 02:56 AM   #7
Mechan1k
Moderator
Donating Member1
 
Mechan1k's Avatar
 
Join Date: Feb 2005
Location: Kenthurst
Posts: 40,403
Valued Contributor: For members whose non technical contributions are worthy of recognition. - Issue reason: Brings a wealth of knowledge to the forums and is frequently giving helpful advice. Technical Contributor: For members who share their technical expertise. - Issue reason: Always willing to help out with technical information. 
Default

Sounds like a dodgy connection to your fuel sender ... a dodgy sender ... or a dodgy float.

At least yours is say it is empty.

Mind at one point said I had 200km left to go .... but was actually dead empty ... I managed to roll into a servo ... only to find the servo didn't have an LPG pump ... spewing.
Mechan1k is offline   Reply With Quote Multi-Quote with this Post
Reply


Forum Jump


All times are GMT +11. The time now is 01:08 PM.


Powered by vBulletin® Version 3.8.5
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Other than what is legally copyrighted by the respective owners, this site is copyright www.fordforums.com.au
Positive SSL