|
|
|
|
|
|
Welcome to the Australian Ford Forums forum. You are currently viewing our boards as a guest which gives you limited access to view most discussions and inserts advertising. By joining our free community you will have access to post topics, communicate privately with other members, respond to polls, upload content and access many other special features without post based advertising banners. Registration is simple and absolutely free so please, join our community today! If you have any problems with the registration process or your account login, please contact us. Please Note: All new registrations go through a manual approval queue to keep spammers out. This is checked twice each day so there will be a delay before your registration is activated. |
|
|||||||
 |
|
|
Thread Tools | Display Modes |
03-09-2013, 02:35 PM
|
#1 | ||
|
_Oo===oO_
Join Date: Dec 2004
Location: Australia
Posts: 3,305
|
Hi all,
I'm after some advice on clearing leaves out of the heating/cooling ducting. I remember this being somewhat easy on an EA, with two points of access: pull the exterior cowling off (after detaching the windscreen wiper) and pulling out the glovebox to reach a duct. Is this the same on AU's? Any other tips on getting to the leaves/stopping them getting in? Cheers, |
||
|
|
|
08-09-2013, 01:07 AM
|
#2 | ||
|
FF.Com.Au Hardcore
Join Date: Feb 2005
Location: Melb north
Posts: 12,025
|
I was told , it is possible to remove the resistor on the left side of the heater box with the glove box out and shove a flexible bit of tube on the end of a vacuum nozzle, though a have not tried it, i believe someone on here did try it a found it hard going,
but knowing what a sod of a job it is to get the heater box out, personally, i would try that and be a bit inventive in the nozzle department first. |
||
|
|
|
| This user likes this post: |
Leaves Trapped in Heating/Cooling Ducting
Linear Mode
