|
|
|
|
|
|
Welcome to the Australian Ford Forums forum. You are currently viewing our boards as a guest which gives you limited access to view most discussions and inserts advertising. By joining our free community you will have access to post topics, communicate privately with other members, respond to polls, upload content and access many other special features without post based advertising banners. Registration is simple and absolutely free so please, join our community today! If you have any problems with the registration process or your account login, please contact us. Please Note: All new registrations go through a manual approval queue to keep spammers out. This is checked twice each day so there will be a delay before your registration is activated. |
|
|||||||
 |
|
|
Thread Tools | Display Modes |
19-09-2015, 02:39 PM
|
#1 | ||
|
Starter Motor
Join Date: Mar 2010
Posts: 28
|
Hi guys,
Have noticed a rattle under low speed (around 35km/hr) over the last week. Grabbed the front left wheel and gave it a shake. There is a small (mm or two) amount of play. I am guessing loose hub nut or bearing. Is there anything else it may be? I can tighten a wheel hub without much issue but replacing bearings is beyond my tool kit. The car is a 2010 titanium diesel that has done 85,000km |
||
|
|
|
19-09-2015, 06:53 PM
|
#2 | ||
|
FF.Com.Au Hardcore
Join Date: Sep 2012
Location: Perth WA
Posts: 845
|
Not a big job to replace wheel bearing only basic tools needed a socket and ring spanner set and a pair of plyers plus some wheel bearing grease, just undo the calliper bolt and lift up out of the way and remove the hub nut and the disc will come off and tap the bearings out.
just pack the new bearings with the grease and tap them in and put it back together. |
||
|
|
|
|
19-09-2015, 07:07 PM
|
#3 | ||
|
Starter Motor
Join Date: Mar 2010
Posts: 28
|
Ah ok. Had a quick google and people were using weird 3 arm things to remove the bearings that kind of scared me off.
|
||
|
|
|
|
19-09-2015, 08:12 PM
|
#4 | ||
|
FF.Com.Au Hardcore
Join Date: Sep 2012
Location: Perth WA
Posts: 845
|
That's only to remove the whole hub assembly
|
||
|
|
|
|
19-09-2015, 09:43 PM
|
#5 | ||
|
FF.Com.Au Hardcore
Join Date: Dec 2012
Location: Adelaide
Posts: 2,252
|
Surely the bearing needs to be pushed out with more force than a hammer! and reset with a press?
JP |
||
|
|
|
|
19-09-2015, 11:01 PM
|
#6 | ||
|
FF.Com.Au Hardcore
Join Date: Sep 2012
Location: Perth WA
Posts: 845
|
|
||
|
|
|
|
20-09-2015, 09:58 AM
|
#7 | ||
|
Starter Motor
Join Date: Mar 2010
Posts: 28
|
Thanks but thas for a b series falcon. The mondeo front is quite a bit different i think. It needs a 32mm socket as well from what i have seen
|
||
|
|
|
|
20-09-2015, 10:21 AM
|
#8 | ||
|
Starter Motor
Join Date: Mar 2010
Posts: 28
|
I should add that there is no grinding/bearing shreading sounds. Just a light knock occasionally and the wheel is very slightly loose. I am leaning towards the hub nut being loose.
|
||
|
|
|
Loose front wheel
Linear Mode
