|
|
|
|
|
|
Welcome to the Australian Ford Forums forum. You are currently viewing our boards as a guest which gives you limited access to view most discussions and inserts advertising. By joining our free community you will have access to post topics, communicate privately with other members, respond to polls, upload content and access many other special features without post based advertising banners. Registration is simple and absolutely free so please, join our community today! If you have any problems with the registration process or your account login, please contact us. Please Note: All new registrations go through a manual approval queue to keep spammers out. This is checked twice each day so there will be a delay before your registration is activated. |
|
|||||||
 |
|
|
Thread Tools | Display Modes |
11-06-2016, 11:23 PM
|
#1 | ||
|
FF.Com.Au Hardcore
Join Date: Jul 2010
Posts: 859
|
how long does one expect a brake light switch to last on a au 2002 xr6 i had mine replaced about 2 years ago and now its failed again is it a comon fault. thanks all
|
||
|
|
|
12-06-2016, 06:48 AM
|
#2 | ||
|
Regular Member
Join Date: Aug 2015
Location: Navarre, Florida
Posts: 55
|
It sorta depends. Late model stoplight switches tend to be lightweight plastic. My experience here in the states is that if the vehicle spends a lot of time with the brake lights on such as a boat load of stop and go traffic or long traffic light waits, the switch will last a much shorter amount of time. For vehicles that go more than stop, it will last longer. Also, check the stop light bulb sockets, if they look overheated it could mean higher resistance and heat in the circuit. Over here Fords seem to be rough on bulb sockets.
|
||
|
|
|
|
12-06-2016, 08:53 AM
|
#3 | ||
|
Donating Member
 Join Date: Jan 2007
Posts: 293
|
Yes, it is a common fault.
OEM seems to last a bit longer than SuperCheapAuto version. Regards, George V |
||
|
|
|
|
12-06-2016, 10:15 PM
|
#4 | ||
|
Regular Member
Join Date: Nov 2008
Posts: 444
|
Make sure you check the sites going into the plug.
I had mine where the terminal had broken the wire fractionally and caused an intermittent problem. Fixed with 2 new flag terminals crimped on to the wires.
__________________
2003 BA XR6 N/A SEDAN IN ACID RUSH CURRENT MODS: PACEMAKER 4490's, 3 INCH HIGH FLOW CAT, F6 CAI, K&N PANEL FILTER FUTURE MODS: CAT BACK EXHAUST, MAG WHEELS |
||
|
|
|
brake light switch
Linear Mode
