|
|
|
|
|
|
Welcome to the Australian Ford Forums forum. You are currently viewing our boards as a guest which gives you limited access to view most discussions and inserts advertising. By joining our free community you will have access to post topics, communicate privately with other members, respond to polls, upload content and access many other special features without post based advertising banners. Registration is simple and absolutely free so please, join our community today! If you have any problems with the registration process or your account login, please contact us. Please Note: All new registrations go through a manual approval queue to keep spammers out. This is checked twice each day so there will be a delay before your registration is activated. |
|
|||||||
| The Pub For General Automotive Related Talk |
 |
|
|
Thread Tools | Display Modes |
19-08-2018, 09:34 PM
|
#1 | ||
|
Starter Motor
Join Date: Jan 2017
Posts: 22
|
Hey guys,
I tried to find some info on this but couldn't figure it our. I have 08 XR8 Ute. Hoping to install the seats from a 12 XR6 Series 2 Sedan into my ute. Does anyone know if this will be a straight swap? As always, thank you in advance, Julian |
||
|
|
|
20-08-2018, 04:27 AM
|
#2 | ||
|
FF.Com.Au Hardcore
Join Date: Jun 2010
Location: Perth
Posts: 1,315
|
Hi,
The utes usually have seats that can flip forward, (in order to put items behind the seats) If you don't care about that feature, and can manage with sliding the seats on its rails and adjusting the back rest forward then the sedan seats should fit in the ute. Some high models have electric motors in the seats. XR models usually don't have these. If you are fitting electric seats to a vehicle without them, you will need to patch in wiring for the power supply etc. Cheers, |
||
|
|
|
|
20-08-2018, 07:52 PM
|
#3 | ||
|
Donating Member
 Join Date: Dec 2006
Posts: 5,544
|
The airbag connector is the biggest problem...make sure it is the same...I am not up on utes, but in 08 they might not have had them even?
|
||
|
|
|
|
20-08-2018, 09:07 PM
|
#5 | ||
|
PURSUIT 250
 
Join Date: Mar 2009
Location: sydney
Posts: 5,835
|
The seats just disassemble with a socket set the the leather pulls off the foams then the foam slips off. Each detail on the seat has a corresponding trench and Velcro on the foam.
 Gt leather and foams (mine were crushed) onto Ute frames 
|
||
|
|
|
|
20-08-2018, 09:53 PM
|
#6 | ||
|
CLEVO POWERED
Join Date: Mar 2009
Location: QLD
Posts: 1,625
|
Giant Cranium, can your Driver see over the steering wheel, he looks a tad short?
|
||
|
|
|
| 3 users like this post: |
|
08-09-2023, 07:44 PM
|
#8 | ||
|
Starter Motor
Join Date: May 2023
Posts: 1
|
Cranium thats phenomenal. where on earth did you source GT leather and foams???? love your work.
|
||
|
|
|
Seats FG between 08 and 12. Will they fit?
Re: Seats FG between 08 and 12. Will they fit?
Linear Mode
