|
|
|
|
|
|
Welcome to the Australian Ford Forums forum. You are currently viewing our boards as a guest which gives you limited access to view most discussions and inserts advertising. By joining our free community you will have access to post topics, communicate privately with other members, respond to polls, upload content and access many other special features without post based advertising banners. Registration is simple and absolutely free so please, join our community today! If you have any problems with the registration process or your account login, please contact us. Please Note: All new registrations go through a manual approval queue to keep spammers out. This is checked twice each day so there will be a delay before your registration is activated. |
|
|||||||
| The Pub For General Automotive Related Talk |
 |
|
|
Thread Tools | Display Modes |
24-05-2006, 12:34 AM
|
#1 | ||
|
Starter Motor
Join Date: Apr 2006
Posts: 16
|
can any one help me i am putting a 100 shot of nos on the 4.0l in my ute and am concerned about rod bolt strenght no one does a bolt for it as it has true 8mm bolts have been told by others that the standard bolts will do the job any input would be a help
|
||
|
|
|
24-05-2006, 08:18 AM
|
#2 | ||
|
I build your wish list...
Join Date: Jan 2005
Location: Country Victoria
Posts: 4,484
|
I run a 150 shot and no probs here
on a stock motor i have put through 3 bottles 10lbs each .. Motor is still going fine no noise and i drive it everyday b.t.w. its a EF 160,000km from the wreckers motor in a EL
__________________
If it weren’t for physics and the law enforcement, I’d be unstoppable.
|
||
|
|
|
|
25-05-2006, 05:03 PM
|
#3 | ||
|
Starter Motor
Join Date: Apr 2006
Posts: 16
|
thanks for the input trick xd i thought while its apart i would strenghten it a bit with out going over board
|
||
|
|
|
rod bolts
Linear Mode
