|
|
|
|
|
|
Welcome to the Australian Ford Forums forum. You are currently viewing our boards as a guest which gives you limited access to view most discussions and inserts advertising. By joining our free community you will have access to post topics, communicate privately with other members, respond to polls, upload content and access many other special features without post based advertising banners. Registration is simple and absolutely free so please, join our community today! If you have any problems with the registration process or your account login, please contact us. Please Note: All new registrations go through a manual approval queue to keep spammers out. This is checked twice each day so there will be a delay before your registration is activated. |
|
|||||||
 |
|
|
Thread Tools | Display Modes |
04-09-2006, 09:30 AM
|
#1 | ||
|
Starter Motor
Join Date: Sep 2006
Posts: 2
|
My KC Laser drops out of Drive unexpectedly. Have replaced front engine mount a couple of times! cannot find out why engine mount rubber breaks and if this is related to jumping out of "D". Any assistance would be most appreciated.
|
||
|
|
|
04-09-2006, 02:14 PM
|
#2 | ||
|
Over Thinker
Join Date: Dec 2005
Location: Ipswich Qld
Posts: 1,351
|
too much engine movement - can you buy a better quality engine mounts
or fit an extra engine damper to stop forward movement the movment may cause the cable to pull the selector out of postion If drive comes back with a bit of fiddleing in the shifter then it isnt a gearbox problem
__________________
My car goes Brumm Brumm |
||
|
|
|
|
04-09-2006, 03:10 PM
|
#3 | ||
|
Guest
Posts: n/a
|
Check the gearbox mount and the rear engine mount
Thats whats causing the front mount to go all the time, as well as slipping out of drive. My old pulsar's gearbox and rear mount were gone, and couldn't hold 2nd or 4th, as the engine was pushing the gear selector rod backwards(causing the stick to move forwards) |
||
|
|
KC Auto drops out of 'Drive'
Linear Mode
