|
|
|
|
|
|
Welcome to the Australian Ford Forums forum. You are currently viewing our boards as a guest which gives you limited access to view most discussions and inserts advertising. By joining our free community you will have access to post topics, communicate privately with other members, respond to polls, upload content and access many other special features without post based advertising banners. Registration is simple and absolutely free so please, join our community today! If you have any problems with the registration process or your account login, please contact us. Please Note: All new registrations go through a manual approval queue to keep spammers out. This is checked twice each day so there will be a delay before your registration is activated. |
|
|||||||
 |
|
|
Thread Tools | Display Modes |
21-01-2021, 08:44 PM
|
#31 | ||
|
Regular Member
Join Date: Feb 2010
Location: Melb
Posts: 167
|
These are a bit of a lottery. I've had to do it before (pain in the rear) but my current manual XR8 has 220,000 on the original bolts.
As said above it's likely caused by poorly formed mount plates... a grade 5 7/16 bolt has a yield strength of ~40 kilonewton, endurance limit would be ~20kN, so the two of them *should* handle ~40kN loads indefinitely without fatigue failure. A wheezer will put about 1300Nm torque into the mounts in first gear (3:1 gear ratio), the bolts are about 20cm from the crank centreline so that's about 6.5kN into the bolts. So a safety factor of about 6x below the endurance limit which should be plenty even allowing for shock loading from clutch dumps, axle tramp etc. But if the mounts are not true (I'd bet some came from the factory like that) and load the bolts unevenly all bets are off. |
||
|
|
| This user likes this post: |
|
22-01-2021, 06:26 AM
|
#32 | ||
|
Regular Member
Join Date: Oct 2017
Location: Macleay Island
Posts: 103
|
Use 50/50 acetone/ Auto trans fluid. It's basically all bolt release products.
bye |
||
|
|
|
Re: Brokoen bolt on engine mount
Linear Mode
