AU2 front suspension arms

[XC50077]

AU2 SR Superpro vs Rubber.
My AU I6 time for front end rebuild 212k, Ball joints gone top and bottom, bushes not bad but probably need to replace anyhow. Can get exchange arms with Superpro bushes or Rubber and new ball joints fitted already in arms. Most driving is 50/50 urban and country roads. Like the comfort of existing rubber items and I am over 70. Any advice , recommendations welcome.
Cheers

[deeppocket]

Originally Posted by XC50077

AU2 SR Superpro vs Rubber.

My AU I6 time for front end rebuild 212k, Ball joints gone top and bottom, bushes not bad but probably need to replace anyhow. Can get exchange arms with Superpro bushes or Rubber and new ball joints fitted already in arms. Most driving is 50/50 urban and country roads. Like the comfort of existing rubber items and I am over 70. Any advice , recommendations welcome.

Cheers

Did mine 2 years ago & put the replacement arms with rubber, as my advice from suspension expert was keep away from silicone, ride too hard.

Sent from my Moto G (5) Plus using Tapatalk

[Pis-ton broke]

i did plastic bushes in my xr6 ba, that was a big mistake, its not a race car.
after it was done, it jarred up my back bad.