|
|
|
|
|
|
Welcome to the Australian Ford Forums forum. You are currently viewing our boards as a guest which gives you limited access to view most discussions and inserts advertising. By joining our free community you will have access to post topics, communicate privately with other members, respond to polls, upload content and access many other special features without post based advertising banners. Registration is simple and absolutely free so please, join our community today! If you have any problems with the registration process or your account login, please contact us. Please Note: All new registrations go through a manual approval queue to keep spammers out. This is checked twice each day so there will be a delay before your registration is activated. |
|
|||||||
 |
|
|
Thread Tools | Display Modes |
28-05-2012, 10:56 AM
|
#1 | ||
|
2many projects No time/$
Join Date: Dec 2007
Posts: 408
|
Rather than buy new guards I have some reasonably good standard ones that I could convert. As I said originality not an issue for a couple of my projects. Looked at the Rare Spare insert & they look OK with a bit of finishing. Has anyone used them? What was your opinion?
 |
||
|
|
|
28-05-2012, 01:25 PM
|
#2 | ||
|
Restoration Garage
Join Date: Nov 2009
Location: Victoria
Posts: 809
|
Yeh a few people on here have used them, i used them on my ute. you can obviously see the ripples on the outer edge, i cut all the outer edge off, so it was just the insert (if that makes sence), attached is what im on about.
http://cgi.ebay.com.au/ws/eBayISAPI....m=330494518913 Measurements:  And mine all painted up: 
__________________
2012 Ford Ranger XL Supercab 3.2D 1973 XA Falcon Ute 1973 XA Falcon Superbird Coupe 1975 XB Falcon Sedan |
||
|
|
|
XA GT guard inserts from Rare Spares. Any good?
Linear Mode
