|
|
|
|
|
|
Welcome to the Australian Ford Forums forum. You are currently viewing our boards as a guest which gives you limited access to view most discussions and inserts advertising. By joining our free community you will have access to post topics, communicate privately with other members, respond to polls, upload content and access many other special features without post based advertising banners. Registration is simple and absolutely free so please, join our community today! If you have any problems with the registration process or your account login, please contact us. Please Note: All new registrations go through a manual approval queue to keep spammers out. This is checked twice each day so there will be a delay before your registration is activated. |
|
|||||||
 |
|
|
Thread Tools | Display Modes |
05-11-2020, 10:25 AM
|
#1 | ||
|
Regular Member
Join Date: Jan 2017
Posts: 168
|
Hi I need a lighter socket in the tray of my au2 xr8 for a fridge where can I run it from it must turn off when I turn the key off
|
||
|
|
|
05-11-2020, 12:52 PM
|
#2 | ||
|
DIY Tragic
Join Date: Apr 2018
Location: Sydney, more than not. I hate it.
Posts: 22,437
|
I’d suggest you run new wire from the engine bay fuse box, and ground it on the chassis close to the socket point. Use the output from the EEC relay to provide a trigger for your new relay. That way it will go on when the car starts and turn off when you stop the motor.
Run your positive feed in well-supported split convoluted tubing on the right side of the chassis, to stay clear of the fuel lines. Fuse it before the relay. |
||
|
|
|
10-11-2020, 10:36 AM
|
#3 | ||
|
Regular Member
Join Date: Jan 2017
Posts: 168
|
You lost me at relays
If I run 2 ? wires from the under bonnet fuse box back to the tray and get a lecy to connect how heavy should the wire be |
||
|
|
|
|
10-11-2020, 11:02 AM
|
#4 | ||
|
DIY Tragic
Join Date: Apr 2018
Location: Sydney, more than not. I hate it.
Posts: 22,437
|
Do you need to run a lighter socket or is this your preference? Anderson plug will take more current.
|
||
|
|
|
|
11-11-2020, 11:18 AM
|
#5 | ||
|
Regular Member
Join Date: Jan 2017
Posts: 168
|
The fridge has 240 volts and a lighter connection don't know what a Anderson is
|
||
|
|
|
|
11-11-2020, 12:10 PM
|
#6 | ||
|
DIY Tragic
Join Date: Apr 2018
Location: Sydney, more than not. I hate it.
Posts: 22,437
|
OK, I’m not trying to be sarcastic but it’s worth having a read on Anderson plugs. They’re well known in the 4x/off-road crowd. It would be my choice.
Broadmeadows made basic provision for extra wiring, here’s where you put a 6mm eye on your cable and clamp it under the bolt head, above the existing eye:  Overall location view. This cable is permanently live, so long as the battery is connected:  Your eyelet goes to one side of the empty fuse position below. Fuse and relay female terminals are pretty much 1/4” spades with a locking tab. You withdraw the white inserts upwards before fitting the terminals from below, and refit after to secure the whole lot.  Cable sizing reckoner is here, if you want to work it from scratch. Lengths of cable required are always longer than you think! http://www.enerdrive.com.au/wp-conte...able-Chart.pdf |
||
|
|
|
Extra lighter socket
Linear Mode
