|
|
|
|
|
|
Welcome to the Australian Ford Forums forum. You are currently viewing our boards as a guest which gives you limited access to view most discussions and inserts advertising. By joining our free community you will have access to post topics, communicate privately with other members, respond to polls, upload content and access many other special features without post based advertising banners. Registration is simple and absolutely free so please, join our community today! If you have any problems with the registration process or your account login, please contact us. Please Note: All new registrations go through a manual approval queue to keep spammers out. This is checked twice each day so there will be a delay before your registration is activated. |
|
|||||||
| Drag Racing Discuss Drag Racing here be it dirt or tarmac. Sponsored by Sydney Dragway. |
 |
|
|
Thread Tools | Display Modes |
16-02-2010, 02:14 AM
|
#1 | ||
|
Starter Motor
Join Date: Feb 2009
Location: Bunbury,WA
Posts: 15
|
hi fellas,i recently purchased an xf ute super stocker(less motor) from sydney. car has all the best gear and im happy as larry!!!! in the shed is a 562 cube big block ford just jumping to get fired up. i am looking at cutting the front of and fabricating a front clip.can anyone point me in the right direction as far as the best/cost effective strut/steering set up to use?? the car already has wilwood breaks and re fitting these to the front is a must. im a welder/fabricator so that side is not a problem but any other handy tips/pitfalls would be appreciated.
cheers tomo |
||
|
|
xf ute front clip
Linear Mode
