|
|
|
|
|
|
Welcome to the Australian Ford Forums forum. You are currently viewing our boards as a guest which gives you limited access to view most discussions and inserts advertising. By joining our free community you will have access to post topics, communicate privately with other members, respond to polls, upload content and access many other special features without post based advertising banners. Registration is simple and absolutely free so please, join our community today! If you have any problems with the registration process or your account login, please contact us. Please Note: All new registrations go through a manual approval queue to keep spammers out. This is checked twice each day so there will be a delay before your registration is activated. |
|
|||||||
 |
|
|
Thread Tools | Display Modes |
22-07-2013, 06:17 PM
|
#1 | ||
|
Club Moderator
 Join Date: Dec 2004
Location: Tas
Posts: 3,744
|
Howdy All,
My flat mates 06 Zetec has bought up the check engine light today. I put my SCT flash unit on it and it came up with the following codes P116F C276F P0000 I then reset it with the SCT and started the car and it came up with these ones P1100 P0100 P0000 I have found the P1100 and P0100 and they are related to the air flow meter, so was going to check that out and the wiring and air cleaner. Car was only serviced about 2 months ago and has done 116000ks. I haven't driven it since the reset to see if the light comes back on, but it didn't when I started the car after the reset. Any info would be appreciated. |
||
|
|
|
22-07-2013, 07:34 PM
|
#2 | ||
|
FF.Com.Au Hardcore
Join Date: Jul 2008
Location: Melbourne
Posts: 804
|
A code P0100 may mean that one or more of the following has happened: The MAF may be disconnected, or a wiring connection may be bad The MAF sensor may be faulty
P1100 means Airflow meter signal is intermittent Sounds most likely you need to clean all terminals and connectors relating to the airflow meter. |
||
|
|
|
|
22-07-2013, 10:58 PM
|
#3 | ||
|
Club Moderator
Join Date: Dec 2004
Location: Tas
Posts: 3,744
|
Thanks, I will give it a clean tomorrow afterwork and see how it goes.
|
||
|
|
|
|
01-01-2015, 03:59 PM
|
#4 | ||
|
Starter Motor
Join Date: Sep 2013
Posts: 5
|
What is the outcome? No good leaving a thread dead this way.
|
||
|
|
|
06 Focus Zetec engine light
Linear Mode
