|
Welcome to the Australian Ford Forums forum. You are currently viewing our boards as a guest which gives you limited access to view most discussions and inserts advertising. By joining our free community you will have access to post topics, communicate privately with other members, respond to polls, upload content and access many other special features without post based advertising banners. Registration is simple and absolutely free so please, join our community today! If you have any problems with the registration process or your account login, please contact us. Please Note: All new registrations go through a manual approval queue to keep spammers out. This is checked twice each day so there will be a delay before your registration is activated. |
|
|
Thread Tools | Display Modes |
30-11-2008, 06:12 PM | #1 | ||
Regular Member
Join Date: Nov 2008
Posts: 48
|
Off to Queensland raceway soon.
All the mods should be complete by then, and the fiesta is proving to be quite a good track car. Have done the sprint circuit when the car was standard, so this should eb very interesting. I essentially raided the pumaspeed catalogue and got everything imported. Just getting the cams and performance pulley set installed on Tuesday so should be a load of fun. Although the best mod you can do is always suspension and sticky rubber. So mods done so far. KW coil overs ( sensational body control on the track - pretty harsh ride H&R front swaybar ( see above) all available suspension performance bushes ( noticed no difference) performace discs - (better brake cooling) mintex race pads - (noisy but great bite and pedal feel) braided brake lines - (perhaps better pedal feel) replaced fluid with penrite Sin complete millitek exhaust system ( seemed to reduce low end torque considerably- but top end was a bit better) k&n filter system (sounds great but negligable improvement) dreamscience flash tune (made the biggest difference to performance - cured the annoying idle/low speed problems) ridiculous expensive spark plugs and leads - (made no difference) fitted 15 inch wheels with yokohama advans (yet to test the stickyness but the ride is so much more comfortable) [/QUOTE] |
||
30-11-2008, 06:29 PM | #2 | ||
Rated G
Join Date: Dec 2006
Location: The Hills
Posts: 177
|
Sounds like a lot of fun!
I'm sure you tell us how you go....
__________________
05 Fiesta Zetec... unique Tonic body colour,
leather gear shift, floor mats, scuff plates rear spoiler, basic tints, 15" stock alloys |
||
30-11-2008, 06:38 PM | #3 | ||
Broken
Join Date: Dec 2005
Posts: 7,845
|
What you don't have in outright velocity, you're going to get back in corner speed.
Nice track orientated list of mods mate, just don't forget to put full synthetic fluids in the drivetrain. Cheap insurance. Look forward to reading about this little terror on the track. tex
__________________
The Scud GT 11.4 @ 128, 1.88 60ft. |
||
30-11-2008, 06:39 PM | #4 | ||
powered by Ford
Join Date: Jul 2008
Location: Brisneyland
Posts: 362
|
AWESOME - NEW RACE TYRES!
Trust you are with it on the break-in procedure. Few laps at medium pace to get warm and clean off the wax, increase pace to 80% for a couple of laps and then one fast lap and park it for a cool down. A bit of road driving can help to remove the wax, but is very hard to get anywhere near enough heat in them on the road to properly bed them in. Oh - comfortable? compared to what? Car looks great - As somebody once said of my car (which coincidently was also red, and running on steel rims with race rubber) - "that's no b*llsh$t racing" |
||
30-11-2008, 06:49 PM | #5 | ||
Regular Member
Join Date: Nov 2008
Posts: 48
|
Have got redline mt-90 gearbox oil and 30wt raceoil on board.
The oil seemed to help a little with reducing griding when going into reverse, although take it gently The tyres have seen a bit of use on an mx5 so are ready to go! |
||
30-11-2008, 07:05 PM | #6 | ||
Regular Member
Join Date: Nov 2008
Posts: 48
|
talking of comfort - standard car on 17's is fine for the road. With the suspension changes it becomes very annoying.
I was quite surprised how much better it rode on the 15's. |
||
01-12-2008, 01:23 PM | #7 | ||
Motorsport Guru
Join Date: Jan 2005
Location: The Blue Mountains, N.S.W.
Posts: 1,678
|
I've only been to Q.R. once as a spectator at the Shannons Nationals so I reckon you'd have had a ball out there. What terminal speed were you reaching? And from what I recall those tyres are used in the Aust. Proddie Cars Championship so I'd imagine they'd have suited the XR4.
__________________
Interior Enhancements: Footwell Lighting, Brushed Alum. H/brake Handle, 6 Disc In-Dash System. Exterior Enhancements: ST170 Wheels, Richbrook Shorty Aerial, Euro-Spec Hatch Handle. Performance Enhancements: Ate Callipers/EBC Rotors/EBC Greens Stuff Pads, ST170 Suspension, Herrod's Custom Tune, Ford Racing Coated Exhaust Manifold & Bespoke 2.25in Exhaust. Awards: AFD '07 EFOC Best Focus, SFS '09 EFOC Best Focus, SFS '10 RSOC O/all Best Focus, AFD '10 CFC O/all Best Focus. |
||
01-12-2008, 07:10 PM | #8 | ||
'07 Fiesta Lx
Join Date: Oct 2008
Posts: 9
|
think i have seen this thing at Lakeside, looked pretty good then. Have fun at QR
|
||
01-12-2008, 07:14 PM | #9 | ||
Regular Member
Join Date: Dec 2006
Posts: 145
|
very nice!
Did you have to drop the front crossmember to fit the front swaybar?
__________________
2004 Fiesta Zetec Colorado Red Elbach Lowered Coils - Rear sway bar - 12.5mm Axle Spacers - Rear disc brake conversion - 16" MP3 Rims Tinted windows - Tinted Headlight surrounds - Clear side indicators- Phillips Xenon lighting - Colour Coded - ST Rear Spoiler - Smooth Rear Wiper - Ford leather gear knob & boot – Zetec S Sill Covers & Steering wheel - Leather centre armrest - Pioneer USB/CD player - JL Audio 4ch Amp, subwoofer & splits - Short aerial The most "Standard" car I've ever owned!
|
||
01-12-2008, 09:28 PM | #10 | ||
Regular Member
Join Date: Nov 2008
Posts: 48
|
Yeah, I have been to lakeside twice and it is certainly a better track than QR.
Still yet to go around Morgan park but that should suit the fiesta even better. Top speed down the QR front straight in the standard car was about 160, although I am sure a better driver could have pushed it a bit faster down the main straight. Have done 2 sessions at lakeside, 1 pre and post suspension changes. lap times about a second faster, more importantly, my top speed around turn 1 (the kink at lakeside) was about 15k's faster, so it is all about maintaining goood speed onto the straight. Yes the subframe had to be removed, but the guys at Fulcrum on fairfield road fitted all the suspension |
||
01-12-2008, 10:22 PM | #11 | ||
Finally rollin on 20's
Join Date: Sep 2005
Location: Brisbane
Posts: 1,951
|
All you need to do now is put on the hub caps and you have a semi sleeper!! lol
__________________
Fiesta ST..... Colorado Red...... SOLD Territory Turbo Ghia ..... Winter White SOLD - Good bye my little buddy!!!! K&N, F6 Snorkel, Debung, 20" Enix Turbine in Gunmetal, 7 seat rear springs. |
||