|
|
|
|
|
|
Welcome to the Australian Ford Forums forum. You are currently viewing our boards as a guest which gives you limited access to view most discussions and inserts advertising. By joining our free community you will have access to post topics, communicate privately with other members, respond to polls, upload content and access many other special features without post based advertising banners. Registration is simple and absolutely free so please, join our community today! If you have any problems with the registration process or your account login, please contact us. Please Note: All new registrations go through a manual approval queue to keep spammers out. This is checked twice each day so there will be a delay before your registration is activated. |
|
|||||||
 |
|
|
Thread Tools | Display Modes |
23-08-2012, 07:41 PM
|
#1 | ||
|
rexnet
Join Date: Feb 2010
Location: Adelaide, South Australia
Posts: 3,562
|
i need to replace the front wheel studs on my AU III
has anyone done this and is willing to offer me some tips/advice. im putting longer ones in. |
||
|
|
|
23-08-2012, 08:58 PM
|
#2 | ||
|
FF.Com.Au Hardcore
Join Date: Feb 2005
Location: Melb north
Posts: 12,025
|
i have`nt done any studs on these throw away hubs, but usually the studs are splined and once you have access to them(caliper/ rotor off) a sharp rap with a good hammer on threaded end will usually see them pop out, the way i have put them back in is to push the new stud as far as it will go, putting a bunch of washers or a larger nut on the threaded end as needed,
followed by the factory wheel nut flat side in and then tighten up the nut to pull the stud into the spline, if your wanting to keep the old studs without damaging the thread screw the wheel nut on flat side out level with the end of the stud before wacking them. |
||
|
|
|
|
23-08-2012, 09:09 PM
|
#3 | ||
|
rexnet
Join Date: Feb 2010
Location: Adelaide, South Australia
Posts: 3,562
|
So I take the hub off the car? Or leave it on?
But cheers. Seems simple enough. |
||
|
|
|
|
23-08-2012, 09:59 PM
|
#4 | ||
|
Banned
Join Date: Dec 2007
Posts: 3,290
|
id leave it on the car
|
||
|
|
|
|
23-08-2012, 10:19 PM
|
#5 | ||
|
FF.Com.Au Hardcore
Join Date: Feb 2005
Location: Melb north
Posts: 12,025
|
if there's room to get the stud out while it`s on, leave it on, usually there is room.
|
||
|
|
|
|
23-08-2012, 10:37 PM
|
#6 | ||
|
rexnet
Join Date: Feb 2010
Location: Adelaide, South Australia
Posts: 3,562
|
sweeeetttttttt!
|
||
|
|
|
|
25-08-2012, 07:40 PM
|
#7 | ||
|
Regular Member
Join Date: Sep 2007
Posts: 40
|
Have your front wheel bearings been replaced ? If not i would just replace them as the hub/bearing/studs are one unit.
__________________
If you want more inches ,stroke it!! |
||
|
|
|
replacing wheel studs
Linear Mode
