|
|
|
|
|
|
Welcome to the Australian Ford Forums forum. You are currently viewing our boards as a guest which gives you limited access to view most discussions and inserts advertising. By joining our free community you will have access to post topics, communicate privately with other members, respond to polls, upload content and access many other special features without post based advertising banners. Registration is simple and absolutely free so please, join our community today! If you have any problems with the registration process or your account login, please contact us. Please Note: All new registrations go through a manual approval queue to keep spammers out. This is checked twice each day so there will be a delay before your registration is activated. |
|
|||||||
 |
|
|
Thread Tools | Display Modes |
12-09-2020, 05:32 PM
|
#1 | ||
|
Starter Motor
Join Date: Jul 2020
Posts: 2
|
Hi just after some information for the wiring of the trailer module.
Bought everything new from Ford and followed all the instructions but I seem to have issues with the wiring to the CAN BUS. I took it to ford to program the module and they couldn't as I was waiting for it thinking it was a quick in and out job. I have attached a photo of the wiring harness. I reckon violet orange and grey orange are not the correct wires for the CANBUS. any help will be much appreciated. Thanks |
||
|
|
|
12-09-2020, 06:03 PM
|
#2 | ||
|
FF.Com.Au Hardcore
Join Date: Mar 2013
Posts: 7,695
 
|
Are these the same instructions you have?
See post 11 from this thread, I cannot attach them twice? https://www.fordforums.com.au/showthread.php?t=11459382 |
||
|
|
|
12-09-2020, 06:36 PM
|
#3 | ||
|
FF.Com.Au Hardcore
Join Date: Mar 2013
Posts: 7,695
|
With the additional loom you need AMDS7J-19H465-AA, it has 5 connections, A1 A2 A3 A4 & A5. Did you get instructions with this loom?
A2 looks like an earth, A3 and A4 you need to splice up with the Violet/Orange and Grey/Orange respectively. A5 goes to a connector at the front of the car Pin 31 Brown/Orange, A1 then goes to the trailer harness from the towbar itself. MD Mondeo Trailer Wiring Modification..JPG MD Mondeo Trailer Wiring Modification 2.JPG MD Mondeo Trailer Wiring Modification 3.JPG |
||
|
|
|
|
12-09-2020, 07:15 PM
|
#4 | ||
|
Starter Motor
Join Date: Jul 2020
Posts: 2
|
Yes exactly the same instructions. The Ford tech also had the same instructions.
I have spliced the Violet orange and the grey orange to the car harness. Exactly what the instructions said. I showed the photos to the Ford tech and he said there must be other wires. He checked the voltage on the pins at the back (from the added wiring) and he measured 6.7 volts he said it was too high it should be 2.7 and 2.3 volts. |
||
|
|
|
Wiring for towbar Wagon MD 2017 (2018.25)
Linear Mode
