|
Welcome to the Australian Ford Forums forum. You are currently viewing our boards as a guest which gives you limited access to view most discussions and inserts advertising. By joining our free community you will have access to post topics, communicate privately with other members, respond to polls, upload content and access many other special features without post based advertising banners. Registration is simple and absolutely free so please, join our community today! If you have any problems with the registration process or your account login, please contact us. Please Note: All new registrations go through a manual approval queue to keep spammers out. This is checked twice each day so there will be a delay before your registration is activated. |
|
|
Thread Tools | Display Modes |
10-12-2017, 09:18 PM | #1 | ||
Starter Motor
Join Date: Nov 2011
Posts: 13
|
To keep things brief:
1. I had problems starting the car; sometimes it would sound 'weak'. I suspected battery or alternator. 2. The car wouldn't start after approximately a week of non-use. 3. I took car in for service, they replaced the battery but I was always sceptical about whether they serviced the car since the first time I went to pick it up, they hadn't actually serviced it so I had to leave it there for another day. 4. When I got the car back I noticed it was revving up to ~3k RPM at start up which I remember sounding higher than normal. 5. Slowly it got worse to the point it was revving at ~4k RPM at start up. 6. The other day (after a week of short-trip use) I went for an hour long drive, and when I would set the cruise control at 60km/h, the car would slowly keep accelerating above the set point with zero pressure on the accelerator. 7. Finally the "Engine Systems Fault" light came on after about an hour of driving, and it started struggling and 'sputtering' a bit. Any idea what would cause: a. High revving at car start up (before it settles down to idle). b. The accelerator to push past the cruise control set point? Does this align with a standard problem/fault? |
||
10-12-2017, 09:41 PM | #2 | ||
FF.Com.Au Hardcore
Join Date: May 2016
Posts: 1,828
|
Hi our focus did that and couldn't work out why turns out there is a vacuum hose behind the inlet manifold that split that could be your cause.
|
||
11-12-2017, 08:52 PM | #3 | |||
Starter Motor
Join Date: Nov 2011
Posts: 13
|
Quote:
It sounds like that's exactly what it was (or potentially another hose). Maybe it's a common fault? |
|||
12-12-2017, 07:01 AM | #4 | ||
FF.Com.Au Hardcore
Join Date: Jan 2009
Location: Victoria
Posts: 877
|
Common problem. https://fordforums.com.au/showthread.php?t=11445733
|
||