|
Welcome to the Australian Ford Forums forum. You are currently viewing our boards as a guest which gives you limited access to view most discussions and inserts advertising. By joining our free community you will have access to post topics, communicate privately with other members, respond to polls, upload content and access many other special features without post based advertising banners. Registration is simple and absolutely free so please, join our community today! If you have any problems with the registration process or your account login, please contact us. Please Note: All new registrations go through a manual approval queue to keep spammers out. This is checked twice each day so there will be a delay before your registration is activated. |
|
|
Thread Tools | Display Modes |
21-08-2010, 06:39 PM | #1 | ||
FF.Com.Au Hardcore
Join Date: Nov 2008
Location: Melbourne, Vic
Posts: 1,121
|
Hi all,
Well at the rate i am going with getting everything ready for the V8 conversion I won't be there until mid next year (due to uni and going overseas) therefore I think I will bite the bullet and get it tuned as is. I will then be able to use the flash tuner when converting it to V8. This will cost more but i figure I would be better off enjoying the 6 once tuned until the V8 goes in. Now I have more or less decided to go with a flash tuner however, I would like to preferably go through someone who has tuned AU 6's previously. So if someone could recommend somewhere good that is not 6 hours from Frankston or give any other advice it would be appreciated. I am assuming that the cost will be $1400-1500 including tune and flash tuner box. Cheers, Rhys
__________________
AU III Forte wagon - V8, 5spd man, lowered, 18" Honeycombs, Stock diff rebuilt with TruTrac LSD, Leather Ghia interior/dash, custom twin 2.5" into single 3" exhaust. Wagon Build AU I Forte Sedan - No longer
Toy Car Build |
||
21-08-2010, 06:51 PM | #2 | ||
Resident AFF detailer
Join Date: Dec 2008
Location: Melbourne, VIC
Posts: 3,730
|
If you're in Frankston, check out the guys at Pit Lane Performance - they are a site sponsor, and probably not too far from you!
__________________
No longer an 'active' detailer. |
||
21-08-2010, 06:56 PM | #3 | ||
FF.Com.Au Hardcore
Join Date: Nov 2008
Location: Melbourne, Vic
Posts: 1,121
|
Yeah i was thinking about them. However, when i spoke to him a long long time ago he was mainly doing B series cars. Would certainly be interested to hear from anyone who has been there at all.
__________________
AU III Forte wagon - V8, 5spd man, lowered, 18" Honeycombs, Stock diff rebuilt with TruTrac LSD, Leather Ghia interior/dash, custom twin 2.5" into single 3" exhaust. Wagon Build AU I Forte Sedan - No longer
Toy Car Build |
||
21-08-2010, 07:00 PM | #4 | ||
www.sctflashtuning.com
Join Date: Jan 2005
Posts: 3,142
|
Go and see Pitlane , good honest people that do great work.
__________________
Australia's No1 Ford Enhancement Specialist 103 Northgate Drive Thomastown VIC 3074 Phone: 03 9464 5100 Fax: 03 9464 5166 |
||
21-08-2010, 07:40 PM | #5 | ||
BA GT-P Owner
Join Date: Jan 2005
Location: In the GT-P
Posts: 1,599
|
I would have to agree with the above comments as i have spoken the person in charge there and being so close would sway me to.
__________________
DAILY DRIVER/TRACK CAR BUILD NUMBER 006 299.5 rwkw's 12.74 @108mph ON MT's ON MAXXIS MAV1's 275/45/17 13.27 @ 106mph
|
||
21-08-2010, 09:52 PM | #6 | ||
OLD SKOOL BABY
Join Date: Apr 2005
Location: Melbourne
Posts: 1,688
|
Pit Lane have serviced and maintained both my Fords and can't fault them in quality and service, they will be doing my tune once the TS is ready to go.
Plus Mick is a passionate guy when it comes to Fords.
__________________
XB Sedan - Trick Mansweto built 351 3V Alloy Headed Cleveland,Demon Carby ontop of CHI Hi Rise Manifold - 600HP 83 F100 XLT - 351 Cleveland C6 Auto wrapped in Black snake skin vinyl, daily tow rig.1976 XB GS COUPE (waiting to start the rebuild)
|
||
21-08-2010, 11:23 PM | #7 | ||
Racing improves the breed
Join Date: Apr 2006
Location: SE Melbourne
Posts: 3,982
|
+1 for Pit Lane, Mick is magic tuning with a flash tune and will treat your car like it's his own
__________________
1970 Mini Cooper S Historic Group Nc Touring car 1964 Mini Cooper S Historic Group Nb Touring car 2024 Subaru Outback Touring XT Victorian Hill Climb Championship |
||
22-08-2010, 10:37 PM | #8 | ||
FF.Com.Au Hardcore
Join Date: Nov 2008
Location: Melbourne, Vic
Posts: 1,121
|
Well thanks for the feedback everyone. I have spoken to mick about 12 months ago and found he knew his stuff really well. I am glad to hear that others have had dealings with him as i would expect from my short chat with him. So i know where i am heading tomorrow morning.
Cheers, Rhys
__________________
AU III Forte wagon - V8, 5spd man, lowered, 18" Honeycombs, Stock diff rebuilt with TruTrac LSD, Leather Ghia interior/dash, custom twin 2.5" into single 3" exhaust. Wagon Build AU I Forte Sedan - No longer
Toy Car Build |
||
23-08-2010, 08:20 PM | #9 | ||
FF.Com.Au Hardcore
Join Date: Nov 2008
Location: Melbourne, Vic
Posts: 1,121
|
Just a quick question. Should i need to replace the thermostat or the plugs before getting a tune or should it be ok with the standard ones?? Also, should i expect any costs on or above the SCT flash tuner and the tune itself which will be approx $1500??
__________________
AU III Forte wagon - V8, 5spd man, lowered, 18" Honeycombs, Stock diff rebuilt with TruTrac LSD, Leather Ghia interior/dash, custom twin 2.5" into single 3" exhaust. Wagon Build AU I Forte Sedan - No longer
Toy Car Build |
||
23-08-2010, 08:32 PM | #10 | ||
FF.Com.Au Hardcore
Join Date: Feb 2005
Location: Pit Lane
Posts: 11,867
|
Was that you that dropped into work today, ifso you should have said who you were, was a little hectic in the shop this morning.
Yes you should have your car tuned in the best mechanical condition you can put it in, that means good plugs, clean air and fuel filters, fresh engine oil etc, you don't want to have any of these items holding you back from a good result. If these things are all good there should be no extra costs involved in tuning unless something is holding the car back and then it should be discussed with you before rectifying/replacing, so you are aware of all costs
__________________
Pit Lane Performance 20 Rosella St Frankston 03 9783 8122 Authorised Streetfighter, Pcmtec , SCT & HP Tuners Tuning Agent,
|
||
23-08-2010, 08:43 PM | #11 | |||
FF.Com.Au Hardcore
Join Date: Nov 2008
Location: Melbourne, Vic
Posts: 1,121
|
Quote:
Cheers, Rhys
__________________
AU III Forte wagon - V8, 5spd man, lowered, 18" Honeycombs, Stock diff rebuilt with TruTrac LSD, Leather Ghia interior/dash, custom twin 2.5" into single 3" exhaust. Wagon Build AU I Forte Sedan - No longer
Toy Car Build |
|||
23-08-2010, 08:52 PM | #12 | ||
FF.Com.Au Hardcore
Join Date: Feb 2005
Location: Pit Lane
Posts: 11,867
|
No worries Rhys
probably a good idea to get the starter sorted as the car would be stopped and started a heap of times during tuning. It maybe wise to get your mechanic to do a full service and tune on the car with a good check over to make sure all is good, you don't want anything breaking while on the dyno, although at that mileage you would not expect any mechanicals issues that would fail on the dyno. If you don't have a mechanic we can do this for you also.
__________________
Pit Lane Performance 20 Rosella St Frankston 03 9783 8122 Authorised Streetfighter, Pcmtec , SCT & HP Tuners Tuning Agent,
|
||
23-08-2010, 10:10 PM | #13 | ||
FF.Com.Au Hardcore
Join Date: Nov 2008
Location: Melbourne, Vic
Posts: 1,121
|
Yeah i am hoping to do the oil/filter this weekend. Did it about 5000kms ago. Will put new plugs in too and maybe new leads but they should be fine. I generally do as much as i can, what i can't i get Mick and Paul around the corner at pro street to do for me. The starter motor is ok but it is grabbing a little once started. I may do it this weekend to if i have time.
__________________
AU III Forte wagon - V8, 5spd man, lowered, 18" Honeycombs, Stock diff rebuilt with TruTrac LSD, Leather Ghia interior/dash, custom twin 2.5" into single 3" exhaust. Wagon Build AU I Forte Sedan - No longer
Toy Car Build |
||
26-08-2010, 04:20 PM | #14 | ||
The Monty
Join Date: Oct 2007
Location: Geelong
Posts: 1,226
|
look forward to seeing the results before the tune and after so let us know.
thanks |
||
23-10-2010, 08:20 AM | #15 | ||
Resident AFF detailer
Join Date: Dec 2008
Location: Melbourne, VIC
Posts: 3,730
|
Any updates on this??
__________________
No longer an 'active' detailer. |
||
23-10-2010, 08:21 AM | #16 | ||
FF.Com.Au Hardcore
Join Date: Apr 2009
Location: jimboomba
Posts: 4,638
|
i think theres some updates on his build thread
__________________
Welder/Fabricator at Beaudesert Exhuast Posted by Xcabbi, Does it slap or rattle? Rattle is more to do with timing chains and tensioners. Slap is more to do with lifters, rings, bearings or GENIII boat anchors |
||
23-10-2010, 09:38 AM | #17 | ||
Teh Baest
Join Date: Jan 2007
Location: Hills Area, NSW
Posts: 649
|
check his signature
__________________
1999 Liquid Silver AU Show: XR6 Kit, Low, RDA Slotted's F&B, Fully Tabouli Sound System, Altezza Tailights (Good ones!) Go: K&N Pod w/ 3" intake, XR6T Snorkel, Pacie Comp 4480's, 2.5" Cat Back, CMS Stg2 Cam, Custom Tune, Tranny Cooler Coming..CMS Stg2A Cam, 68mm TB Later.. 4.5L w/ BOOOOOOOOOOST or XR6T or AUIII XR8 220 Currently: 151kW (165 on other dynos ) |
||
23-10-2010, 10:54 AM | #18 | |||
Resident AFF detailer
Join Date: Dec 2008
Location: Melbourne, VIC
Posts: 3,730
|
Quote:
__________________
No longer an 'active' detailer. |
|||