|
|
|
|
|
|
Welcome to the Australian Ford Forums forum. You are currently viewing our boards as a guest which gives you limited access to view most discussions and inserts advertising. By joining our free community you will have access to post topics, communicate privately with other members, respond to polls, upload content and access many other special features without post based advertising banners. Registration is simple and absolutely free so please, join our community today! If you have any problems with the registration process or your account login, please contact us. Please Note: All new registrations go through a manual approval queue to keep spammers out. This is checked twice each day so there will be a delay before your registration is activated. |
|
|||||||
 |
|
|
Thread Tools | Display Modes |
08-01-2016, 11:37 AM
|
#1 | ||
|
Regular Member
Join Date: Dec 2012
Posts: 106
|
extracts and exhurest from a xr8 ute bolt stright on to the 5.6 pursuit ute ?
|
||
|
|
|
09-01-2016, 11:20 AM
|
#2 | ||
|
Regular Member
Join Date: Feb 2010
Location: Brisbane , Queensland
Posts: 204
|
The extractors will but the pursuit has a slightly different exhaust system.
This is due to the 2 piece tail shaft centre bearing mount. Also the rear tail section on the pursuit is longer to protrude past the rear bumper skirt on the pursuit. I purchased a new off the shelf system for a xr8 ute and found out the hard way.Had to modify.It was a manta system , very nice system. |
||
|
|
|
ute
Linear Mode
