|
|
|
|
|
|
Welcome to the Australian Ford Forums forum. You are currently viewing our boards as a guest which gives you limited access to view most discussions and inserts advertising. By joining our free community you will have access to post topics, communicate privately with other members, respond to polls, upload content and access many other special features without post based advertising banners. Registration is simple and absolutely free so please, join our community today! If you have any problems with the registration process or your account login, please contact us. Please Note: All new registrations go through a manual approval queue to keep spammers out. This is checked twice each day so there will be a delay before your registration is activated. |
|
|||||||
| The Pub For General Automotive Related Talk |
 |
|
|
Thread Tools | Display Modes |
11-02-2023, 10:45 AM
|
#1 | ||
|
FF.Com.Au Hardcore
Join Date: May 2006
Posts: 1,110
|
With later model engines commonly used in our early Fords, is there a legal requirement to have an emission control device for the fuel tank as well as a PVC valve.
Especially if "Engineer Certification" is involved? |
||
|
|
|
12-02-2023, 11:15 AM
|
#2 | |||
|
Regular...with metamusal
 Join Date: Oct 2009
Location: Geeeloong
Posts: 6,783
|
Quote:
i have no idea re what your asking ..... how ever if an engineer is involved should you not have talked with them about this requirement?. if not involved with an engineer currently - have a chat to one. |
|||
|
|
|
|
12-02-2023, 12:03 PM
|
#3 | ||
|
FG XR6 Ute & Sedan
 Join Date: Oct 2006
Location: Bibra Lake WA
Posts: 23,612
|
Yes in most states you need the ADR legislated one way vented cap and the carbon canister system.
__________________
regards Blue |
||
|
|
|
| This user likes this post: |
|
12-02-2023, 02:04 PM
|
#4 | ||
|
Starter Motor
Join Date: Aug 2011
Posts: 8
|
The above advice you have been given is good. However the rules can vary from state to state depending on the situation.
The document the states and territories refer to is VSB14, with a link below. https://www.infrastructure.gov.au/in...bulletins/ncop Read the first page (and only) carefully from top to bottom. The only thing you need to read from the Documents section is NCOP03 which has a link to a .pdf to click on. This will take you to the engine section which has an index on the 4th page. Section 3 will refer you to page 13 which gives you a rough overview of what you may need to do. You have not specified what engine you are fitting to what vehicle. This is where you need to seek the services of an engineer approved by your registration authority to guide you further. Unfortunately this system is in reality a rolled gold shining turd of government ineptitude at both Federal and especially some State levels. It is difficult to navigate, confusing and can be costly for enthusiasts to use. It is important to seek information only from capable people who have direct current experience with your local system. Best of luck. A much better system can be found in NZ. |
||
|
|
|
Emission control from fuel tank vent.
Linear Mode
