|
Welcome to the Australian Ford Forums forum. You are currently viewing our boards as a guest which gives you limited access to view most discussions and inserts advertising. By joining our free community you will have access to post topics, communicate privately with other members, respond to polls, upload content and access many other special features without post based advertising banners. Registration is simple and absolutely free so please, join our community today! If you have any problems with the registration process or your account login, please contact us. Please Note: All new registrations go through a manual approval queue to keep spammers out. This is checked twice each day so there will be a delay before your registration is activated. |
|
|
Thread Tools | Display Modes |
09-03-2006, 09:59 PM | #1 | ||
Starter Motor
Join Date: Mar 2006
Posts: 1
|
Please be kind - I am new here - but can anyone tell me how to remove the radio from a 1997 laser?
Any advice much appreciated. Brew |
||
19-03-2006, 08:58 PM | #2 | ||
Over Thinker
Join Date: Dec 2005
Location: Ipswich Qld
Posts: 1,351
|
can you post a pic of the setup in your car
if its in the dash then there is a lot of plastic intertior to undo you might break something or mix up the wiring ? sure you dont want to leave it to a car radio fitter ( yellow pages )?
__________________
My car goes Brumm Brumm |
||
25-03-2006, 11:24 AM | #3 | ||
Starter Motor
Join Date: Jan 2006
Posts: 8
|
On either side of the front face of the radio, there are black plastic bits of trim.
Remove these by sliding them off the front of the radio. Underneath them is 4 holes that you put a small rod down to release the metal clips that hold the radio in place. Obviously you will have to remove all the wiring/aerial from the back of the radio before pulling it out fully. |
||
27-10-2006, 06:29 PM | #4 | ||
Starter Motor
Join Date: Oct 2006
Posts: 4
|
I'm also flumixed ...
|
||