series 2 bonnet

StealthAu · 02-01-2007, 11:52 AM

hey guys, in the process of setting up a shaker cai for my series 1 i6. Also plan on replacing the bodykit, unsue as which path I'll take. One thought was a TS50 kit, if thats the case will have 2 swap bonnets. Now the series 1 bonnet suports centre where I'll have to cut out, was hopping some of you could post pics of the under side of a series 2 bonnet so I can decide weither to brake out the grinder or get a new bonnet first.

StealthAu · 02-01-2007, 01:04 PM

anyone?

au2sw · 02-01-2007, 01:48 PM

shaker and ts50 kit would look s**t hot. perhaps go with barra bonnet bulge if u change the bonnet? awc do them to suit au, also they do t series kits. good luck with which ever way u go

JC · 02-01-2007, 02:12 PM

Quote:

Originally Posted by stockoau

hey guys, in the process of setting up a shaker cai for my series 1 i6. Also plan on replacing the bodykit, unsue as which path I'll take. One thought was a TS50 kit, if thats the case will have 2 swap bonnets. Now the series 1 bonnet suports centre where I'll have to cut out, was hopping some of you could post pics of the under side of a series 2 bonnet so I can decide weither to brake out the grinder or get a new bonnet first.

I think most would still have the insulation matting still attached to the underside of the bonnet, so I doubt you'll get a shot of one at all. I wouldn't think it would be too different to an AU1 though.

StealthAu · 02-01-2007, 03:21 PM

yeah, pobablly have the same issues, just not keen on cutting out the supports where they group

StealthAu · 02-01-2007, 03:23 PM

i think i might try and get 1 anyway, think it will look less dicky poking through a series 2 bonnet